Electronics Forum | Tue Sep 24 23:03:14 EDT 2002 | redmary
we used the ball bonding, just normal chip on board. as I know the the electroless Ni/immersion Au, the gold thickness is about 0.13um at most, what about chemical plating or electrolytic plating? any experience on it, thanks
Electronics Forum | Wed Mar 01 11:51:04 EST 2006 | ajaygarg1980
we are observing voids in solder ball bonding process using laser.Final metal finish is of Au on Cu.Can anyone tell me the reasons or solution for this problem.We are not using any flux at all.
Electronics Forum | Mon Jun 18 16:48:00 EDT 2001 | Gil Zweig
We have found a significant number of PBGA problems associated with physical deformation of the package. Deformations such as dishing (potatoe chipping) and delamination under the die (popcorning). These can be detected by x-ray by the variation patt
Electronics Forum | Thu Feb 26 10:06:12 EST 2009 | bandjwet
Does anyone know of any vendors who can supply "dummy" parts to practice ball wire bonding of gold to help train/certify operators? Thanks BWET
Electronics Forum | Mon Jun 18 19:22:38 EDT 2001 | Gil Zweig
Dave; See my answer to "Alternate to X-ray" The combination of endoscope optical inspection with x-ray inspection provides the most effective means of BGA inspection. Transmission x-ray provides a very rapid means of qualifying then process control o
Electronics Forum | Mon Feb 06 15:50:10 EST 2006 | ajaygarg1980
Hi, We are electrodepositing Au(0.25 to 0.5 microns) on Cu & using solder ball bonding process via laser.We are getting lots of voids within the solder (not kirkendall voids). Can anyone shed some light on this problem.We are not using any flux.Pre
Electronics Forum | Tue Jun 04 19:33:16 EDT 2002 | rob_thomas
Dave's estimation is pretty conservative but there is a lot of equipment out there and a lot of people happy to make a sale.Implementing both mentioned processes it's difficult and time consuming .Even if you get good training from whoever sells you
Electronics Forum | Thu Oct 08 11:33:16 EDT 2009 | cab
We are currently wirebonding MCMs with surface components located in very close proximity to wirebond pads, which are gold plated. We are ball bonding with 99.99% Au wire. Normally we do not have problems, however if product has been reflowed seve
Electronics Forum | Thu Oct 26 17:48:47 EDT 2000 | Dave F
In response to your questions: 1) Suggestions on substrate material FR-4 or something better? Most PBGA are on BT. That might good for you, also. 2) Are there design guidelines for wire bonding pattern on the substrate? Several things: 1 Doesn�t
Electronics Forum | Mon Jun 18 11:23:44 EDT 2001 | Gil Zweig
BGA defects observed with x-ray inspection fall into catagories. One catagory is the obvious defects; i.e. soledr bridges, missing balls, excessive solder voids. The second catagory is the more subtle "potential" defect. This is where variations in