Electronics Forum | Fri Oct 10 11:36:53 EDT 2008 | stevea
Please visit http://www.ascinternational.com to view all the products offered by ASC International. The LaserVision SP3D is the most economical SPI system in the world offered at a base price of only $14,995. The VisionMaster series of products off
Electronics Forum | Thu May 25 10:58:38 EDT 2006 | barryg
Does anyone out there have much experiance with the testronics bench aoi system? We apperently cannot get a demo and are considering the testronics and a mirtec system. Any other systems out there that are in the 25-60k range you would recommend?
Electronics Forum | Thu Jun 22 14:53:03 EDT 2006 | CL
Soboc, Mirtec does have support, service and spare parts in Oxford CT. Chris
Electronics Forum | Wed Feb 18 13:32:58 EST 2015 | stevea
Hi Rob, Not sure if you made any decision on your SPI requirements. The recently established VisionMaster (Long history of previously shuttered business names) company sells products similar too, but not the same as the past "VisionMaster branded" p
Electronics Forum | Tue Jun 13 23:16:32 EDT 2006 | mrduckmann2000
WE LOOKED INTO THE YESTECH AND THE MIRTECH. TODAY WE ARE INSTALLING OUR NEW MIRTECH AOI MACHINE. WE CHOSE THIS MACHINE OVER THE YESTECH BECAUSE OF IT'S OFFERINGS. THE YESTECH WAS A CLOSE SECOND. I WILL POST LATER ON THE PROGRAMMING, THEY ARE ALL
Electronics Forum | Fri Dec 05 08:30:55 EST 2003 | pjc
If your operation is hi-mix low-volume, consider taking a look at some of the bench-top units out there. They are lower cost but can give similar performance as higher cost in-line systems. Some of the bench-tops cannot do solder fillet inspections t
Electronics Forum | Wed Dec 10 15:45:02 EST 2003 | Carl
If your operation is hi-mix low-volume, consider > taking a look at some of the bench-top units out > there. They are lower cost but can give similar > performance as higher cost in-line systems. Some > of the bench-tops cannot do solder fillet
Electronics Forum | Thu May 25 11:09:58 EDT 2006 | John S.
This is a very competitive market segment. We setup 3 of them side by side at the same time on a demo basis in our facility. Work with them as much as you can, and setup an objective test of their capabilities. Good luck. John S.
Electronics Forum | Fri May 26 08:37:07 EDT 2006 | sant
Hi Kindly have a look into the SAKI's benchtop system. I have not used it.But seen the demo. Different technology.Pretty fast and accurate. Definitley would go with them , when we plan. I would also ask others, if they can provide their opinion on
Electronics Forum | Mon Jun 26 10:45:59 EDT 2006 | AOI Tech
Yestech,Yestech,Yestech Best friend to those of us in the US!!!!!!!That's all I'm going to say
