Electronics Forum | Wed Mar 31 09:44:12 EDT 2010 | bandjwet
One thing I would suggest right off the top is to go to a paste printing process. This will get first pass yields higher (usually 10+% higher than gel flux). If you are suggesting that you have good collapse everywhere, the profile is adequate (soun
Electronics Forum | Tue Feb 02 09:47:45 EST 1999 | Justin Medernach
| Hi everybody. | Somebody know any consideration or special care to make a profile for BGA's. | | any advice is aprecied. | | thanks | Al Carrillo | | Hi Al, A BGA should be looked at just like any other surface mount device. However, just
Electronics Forum | Tue Feb 02 17:51:45 EST 1999 | gcollier
| | Hi everybody. | | Somebody know any consideration or special care to make a profile for BGA's. | | | | any advice is aprecied. | | | | thanks | | Al Carrillo | | | | | Hi Al, | A BGA should be looked at just like any other surface mount d
Electronics Forum | Sat Dec 03 16:26:40 EST 2005 | grantp
Hi, I have seen demos of these scopes, and don't think they really show you very much. If you profile your board right, and drill up to solder a thermocouple onto the inner balls of the device so you really know your getting a good profile, I don't
Electronics Forum | Mon Feb 25 11:12:32 EST 2008 | hegemon
It sounds more as though you have a profiling problem primarily, however, if your placement is not square to the board, then you should get your machine setup correct first. After that you can get to the profiling. If the BGA is brought up to tempe
Electronics Forum | Tue Jun 26 15:28:01 EDT 2007 | hegemon
There are a lot of variables in BGA rework in general, and the switch to lead free has only magnified some of the sore spots. Perhaps with a little bit more information someone here can be of help. What is the size and thickness of the PCB? What
Electronics Forum | Mon May 10 16:37:01 EDT 2004 | davef
First some definitions, the two main types for solder masking near BGA pads are: 1 Pad, Non-Solder Mask Defined. In circuit board design, pads with spacing that does not allow solder (usually bumps) on the pads to contact the adjacent solder mask. [
Electronics Forum | Mon Jul 24 15:10:37 EDT 2006 | carln
Here are some additional comments that have been posted on the CircuitNet web site: Fist, the answer is the same regardless of the specific paste type, (leaded or non-leaded). High pressure sprays should never be applied to a stencil. Stencils are
Electronics Forum | Wed Jan 17 20:48:14 EST 2001 | davef
We find that the raw BGA's pad sheared surface has the SnPb solder at various Z heights whereas the assembled BGAs pad leave a smooth layer of SnPb along the pad. Like to understand the cause for the difference. Who could guess? Solder joint streng
Electronics Forum | Wed Jan 12 20:20:54 EST 2000 | Bene
I had the opportunity to spend time with a demo and one on one with the inventor of the Ersa scope inhouse a few months ago. I see the scope complimenting X-ray inspection but not as a substitue. It allows you to view attributes of a solder joint t
