Electronics Forum | Mon Aug 11 14:04:51 EDT 2008 | realchunks
Then your profile is way off. You need a t-couple mounted under the BGA on one of the center balls to measure correctly.
Electronics Forum | Mon Aug 11 10:45:04 EDT 2008 | eyalg
I assume you mean the balls of the BGA, not pads > (laugh it up guys - I said balls). If so, you > may have a no-lead BGA or a high temp BGA. hi I mean that the the balls were left on the board and the BGA pads were found clean. What do you
Electronics Forum | Mon Aug 11 10:47:40 EDT 2008 | dphilbrick
Sounds like bad BGA's to me. I suspect this is rare but you can get black pad on the BGA attach pads just like you get them on a PCB. Do you have un-processed BGA's?(still in package) I would have one tested (not by the manufacturer)!
Electronics Forum | Sat Jun 11 03:26:20 EDT 2016 | nagesh
Hi, I have problem with one of the BGA Top Cap Detached from the Solder Balis attached to the BGA. Advice /Suggest why the Top Cap Has come out. We produced 4150 Pieces & had similar problems with 5 Pieces. Thx in advance for all your suggestions. T
Electronics Forum | Thu Jul 22 21:48:21 EDT 1999 | kyung sam park
Does anyone have any experiences with bga reballing. When I had reworked failed bga part with new part It was good. So I tried to reball bga detached but failed . I guess the cause of fail is thermal shock. IS IT OK TO REBALL BGA PARTS DETACHED ?
Electronics Forum | Thu Jul 22 22:57:14 EDT 1999 | Earl Moon
| Does anyone have any experiences with bga reballing. | When I had reworked failed bga part with new part It was good. | So I tried to reball bga detached but failed . | I guess the cause of fail is thermal shock. | IS IT OK TO REBALL BGA PARTS
Electronics Forum | Mon Jul 26 15:09:31 EDT 1999 | APE South
| Does anyone have any experiences with bga reballing. | When I had reworked failed bga part with new part It was good. | So I tried to reball bga detached but failed . | I guess the cause of fail is thermal shock. | IS IT OK TO REBALL BGA PARTS
Electronics Forum | Sun Jun 12 09:29:41 EDT 2016 | davef
I'd guess that the interconnect pads on the BGA have poor solderability. Confirm this with testing at an independent lab. Work with your supplier to resolve the issue.
Electronics Forum | Fri May 23 15:33:39 EDT 2014 | hegemon
I don't see any visuals that make me think of black pad phenomena. I do note that it appears that pads on the BGA itself have detached and been left on top of some of the solder balls. To me it looks like the temperature profile is not correct, not
Electronics Forum | Mon Jul 26 15:25:27 EDT 1999 | APE South, Jack Reed, Asian Sales Administrator
Dear Mr. Park, Ahn yahn haseo and good day to you. If you are currently in Korea, APE has a direct representative there, Omni-Create in Seoul who can give you full information on BGA reball kits available. Essentially, reball kits are custom made t
