Industry News | 2018-10-18 10:40:04.0
Via Tent-Holes with Solder Mask
Industry News | 2018-12-08 03:29:29.0
SMT Dictionary – Surface Mount Technology Acronym and Abbreviation
Industry News | 2019-11-05 22:07:01.0
Tenting a via refers to covering via with soldermask to enclose or skin over the opening. A via is a hole drilled into the PCB that allows multiple layers on the PCB to be connected to each other. A non tented via is just a via that is not covered with the soldermask layer. Leaving these vias exposed or covered has pros and cons depending on the your design and manufacturing requirements.
Industry News | 2019-11-05 22:08:21.0
Via in pad is the design practice of placing a via in the copper landing pad of a component. Compared to standard PCB via routing, via in pad allows a design to use smaller component pitch sizes and further reduce the PCBs overall size. With component manufactures pushing smaller parts every year and the demand from consumers for smaller devices, the usage of via in pad practices by hardware engineers have become more commonplace. In this article, we will discuss the differences between via in pad and traditional vias, when should you use via in pad, and how to design for it.
Electronics Forum | Fri Nov 03 02:32:56 EST 2006 | shivam
HI ALL, can anybody clear me what is via tenting and via pluging?? second one, if i use via in pad for an.5mm bga what care i should taken, what should be the soldermask open in top and innerlayers for via?how it will directly connect to top layer
Electronics Forum | Fri Dec 17 14:30:42 EST 2004 | Dreamsniper
I goy this issue: Voids in almost every ball of my BGA's prcessed since we changed our BGA via tenting to double tenting. The tenting is done with a dry film application to fill the via from the solder side then apply LPI Mask on the surface of the
Electronics Forum | Fri Dec 17 14:31:52 EST 2004 | Dreamsniper
I got this issue: Voids in almost every ball of my BGA's processed since we changed our BGA via tenting to double tenting. The tenting is done with a dry film application to fill the via from the solder side then apply LPI Mask on the surface of the
Electronics Forum | Sun Dec 26 21:24:55 EST 2004 | tellinghuisen
Dreamsniper What is the rationale for the double plugging? And why from both sides?
Electronics Forum | Fri Jan 21 19:30:11 EST 2005 | Dreamsniper
Hi T2, The purpose of this is that we want to make our rework robust. Whenever we rework BGA's we have solder getting trapped into those 1 sided tented vias and bet yah...they are hard to desolder! And during BGA resoldering these trapped solder will