Electronics Forum | Thu May 06 18:48:22 EDT 2004 | Dreamsniper
SUMMIT 750. My yield is 75%-98%. And they all depend on the pad design, stencil, paste, operator, thermal profile, etc. I have 98% yield on some of our products with good pad design. Process is easy to control. Dreamy
Electronics Forum | Fri Jun 23 08:31:11 EDT 2006 | davef
Sounds like we're going to get questions on how to improve yields on QFP, eh?
Electronics Forum | Fri Apr 13 10:13:30 EDT 2007 | Bob R.
We had a crisis with one BGA causing huge yield losses due to this defect. Nothing we could do with the profile got rid of it. Changing paste didn't get rid of it. It was the BGA warping in reflow, caused the corners to lift up when the solder was
Electronics Forum | Thu Jan 08 16:16:09 EST 2004 | Dean
My first concern would be the choice of solder paste you have. There are better chemistries out there that far exceed the capabilities of the 609 2. Yes, the part will partially float on the solder (assuming plastic qfp). Cross sectioning would sho
Electronics Forum | Thu Oct 28 13:36:14 EDT 1999 | Bart Smith
I am a design engineer and have a circuit board design with a 292 pin BGA on it. The board manufacturer is experiencing a failure rate of about 2.8% on the BGA device due to soldering problems. This is my first experience with BGA. How does the 2.
Electronics Forum | Wed Sep 08 17:23:16 EDT 1999 | Duane Nguyen
| Has anybody have any experience with Top placement of BGA's. GLue descretes on bottom and then wavesolder.? | | | Hi Chris, Why don't you process a double side reflow and use selective wave fixture for wave process. The process will be easie
Electronics Forum | Wed Sep 02 06:50:55 EDT 1998 | Masdi Muhammad
Hi, We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent it. Than
Electronics Forum | Tue Mar 17 07:35:37 EDT 2009 | nagesh
We have the IC placer Fuji-IP3 machine.Can this machine be able to place MicroBGA / BGA with good vision system.My card has almost 8 BGA with 4 MicroBGA?Still now i had placed 1 or 2 BGA(Placement by body centering).In this machine the Y- table keeps
Electronics Forum | Tue Mar 13 11:13:05 EST 2001 | blair
Hi: We are about to build a batch of highly critical control cards with 5 BGA on them. We just recently had a significantly bad yield at our subcontractor in the San Jose area. We feel it is in the reflow profile that was used but are not 100% sur
Electronics Forum | Tue Mar 13 16:05:30 EST 2001 | rob_thomas
Hi, can you definitely attribute the 30%yield to poor bga soldering? What is your high flyer defect encountered on the failed boards.Is this ICT ,flying probe ,functional test yield? Can you determine a defect pattern? Did your subcontractor provided