Electronics Forum | Wed Apr 21 17:08:32 EDT 2004 | dave
Congratulations on your new customer. This could be a keeper. Here's what you're familiar with: Electroless Nickel - per MIL-C-26074 and ASTM-B733. Electroless nickel describes the plating of nickel deposits, which may contain phosphorus and boro
Electronics Forum | Tue Jan 10 20:56:45 EST 2006 | davef
Implementing a Simple Corrosion Test Method to Detect "Black Pad" Phenomenon in Electroless Nickel/Immersion Gold Plating ; BabHui Lee; Circuitree 11/1/03 http://www.circuitree.com/CDA/Archives/34f2b343900f7010VgnVCM100000f932a8c0
Electronics Forum | Wed Jun 14 20:49:32 EDT 2006 | davef
We too do not use ENIG. Too expensive and risky. Implementing a Simple Corrosion Test Method to Detect "Black Pad" Phenomenon in Electroless Nickel/Immersion Gold Plating ; BabHui Lee; Circuitree 11/1/03 http://www.circuitree.com/CDA/Archives/34f2b
Electronics Forum | Mon Nov 03 11:20:08 EST 2008 | boardhouse
Vlad, That was a bad statement to make... Enig should never be thicker than 5 micro inches max. or it will cause embrittlement. This process does self limit but it can put on as much as 10-14 Micro inches which would be a major cause of concern.
Electronics Forum | Thu Jan 22 20:14:44 EST 2009 | herman
If you wish to specify ENIG, your best method of doing it is to simply invoke IPC-4552 (or IPC-4553 for immersion silver) on the fabrication drawing. These IPC standards define ENIG and IAg, and I believe they specify 150-180 uinches of nickel covere
Electronics Forum | Wed Nov 04 11:00:00 EST 2009 | tstrat
That is interesting, I have not seen that as a requirement before. From what I read if it is less than 7 wt% the corrosion resistance is pretty low, but if the value is too high it indicates that "black pad" is present from nickel corrosion. From wha
Electronics Forum | Fri Apr 29 14:16:16 EDT 2011 | ppcbs
Below is the long explanation. This defect is most commonly found with BGA components, but can arrise with all components. I see it happening more now with lead free boards that are being assembled with a no clean flux. Best short term remedy is t
Electronics Forum | Tue Apr 17 10:17:10 EDT 2001 | genny
Hi, ENIG finish is the same reason I came to this forum for the first time a few months ago. I found a bunch of useful information by searching the archives. Check it out. ENIG has some good properties like flatness, and the process control has i
Electronics Forum | Mon Oct 25 17:50:46 EDT 2004 | Mike
I work for a PCB Manufacture and I am looking for info on BGA Pull test or strenght test. I have a CM that is experiencing bga's with some weak joints. they are telling me that when they do their pull test the joints are breaking at the nickel inste
Electronics Forum | Mon Oct 25 21:49:14 EDT 2004 | davef
First, any results of pull or shear tests are unscientific at best. [We pop our BGA from boards with, appropriately enough, a beverage can opener.] Second, we have no have problems with your ENIG specification. Third, as with your customer, we'd e
.jpg)
