Electronics Forum | Fri Jul 30 10:30:23 EDT 1999 | Wolfgang Busko
| | | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That w
Electronics Forum | Fri Jul 30 16:06:22 EDT 1999 | Earl Moon
| | | | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That
Electronics Forum | Wed Jul 28 12:02:48 EDT 1999 | Wolfgang Busko
| | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That wou
Electronics Forum | Tue Apr 14 09:01:36 EDT 1998 | Justin Medernach
| We are having some difficulty soldering a 240 pin Altera device. We use Alpha WS-609, a very generic profile for that solder paste, and a 6 mil stencil with laser cut apertures (1:1 ratio). This is a 20 mil pitch device (aperture size is 10 mils X
Electronics Forum | Wed Jul 28 16:36:30 EDT 1999 | Earl Moon
| | | While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That w
Electronics Forum | Sat Nov 25 18:45:19 EST 2000 | Ashok Dhawan
I am getting black spots / stuff while I run gold finish PCB through reflow soldering process using NC solder paste.The affected spots have intermetalic as black in color. Does not solder very well. I did look at the archieve but could not find info
Electronics Forum | Thu May 05 09:17:58 EDT 2005 | jimmiem
I tried soldering to several of the black pads and was successful, the solder stuck with no hesitation. so i guess this is not truly "black pad"? would that be a correct statement? What causes this blackening that looks like oxidation under the mic
Electronics Forum | Tue Jul 27 17:47:36 EDT 1999 | Earl Moon
| While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That would
Electronics Forum | Thu Aug 21 22:10:07 EDT 2003 | adlsmt
Well, for some reason the board house will pay for the boards but has some issue with paying for the parts on them. Why am I not supprised? Perhaps I have mis-diagnosed the problem. We have found two different board p/n's with the same type of defec
Electronics Forum | Fri May 23 23:58:48 EDT 2014 | edriansyah
Hi Hege. I was not also too confident with the black pad (coz no black residue on the remaining pad). But based on my search on the internet regarding black pad. Most of them shows a very clean BGA Pad after peel off the BGA as the picture reference
