Electronics Forum | Wed Jul 23 08:37:02 EDT 2003 | davef
Your fabricator should be able to re-apply the imm tin very easily. Actually, if we had boards like you describe [and we were sure we didn't mess them up], we'd be be making strong implications that our fab would need to make this right. Don't pin
Electronics Forum | Mon Feb 06 10:02:14 EST 2006 | Yash Sutariya
Sorry. I actually should clarify those slides. Black pad is not associated with tented vias. Also, you can tent vias with soldermask, but this requires the immersion gold process to be completed prior to soldermask. As such, all copper features (
Electronics Forum | Tue Apr 13 11:41:18 EDT 2021 | jeremy_leaf
I have a SAC305 preform with which I am attempting to bond a gold coated component to an ENIG coated PCB pad. I've specified 2 microinches of gold for the ENIG. It worked previously but now with a new batch of boards, I am having an issue where the p
Electronics Forum | Tue Dec 01 07:24:44 EST 1998 | Earl Moon
| Hi folks , | Lately we are seeing a lot of rawcards with black spots on the pads - most of them have Au finish(immersion gold) . We did a lot of inspecton after wave solder and found that only (fine pitch) QFP are affected the most. Our inspection
Electronics Forum | Tue Dec 01 07:54:49 EST 1998 | kallol chakraborty
| | Hi folks , | | Lately we are seeing a lot of rawcards with black spots on the pads - most of them have Au finish(immersion gold) . We did a lot of inspecton after wave solder and found that only (fine pitch) QFP are affected the most. Our inspec
Electronics Forum | Thu Jul 27 21:57:16 EDT 2000 | Dave F
Hi Doug: Responding to your questions: � If gold over nickel is self limiting ... You didn�t say whether you gold plating was electroless or immersion. Electroless is not is self limiting. It can plate up to 5 thou. Expect immersion plated gold to
Electronics Forum | Wed Jun 09 15:03:53 EDT 1999 | Earl Moon
| In past PCB designs I have cleared all traces from all layers | (except pwr/gnd) from fiducial area. It has come to my attention that this is only necessary on the side where fud is placed. Which is the correct method of design using a fidicial?
Electronics Forum | Fri Sep 28 02:48:46 EDT 2018 | teresat2
Principle A layer of photosensitive material (photosensitive oil or dry film) is applied to the copper foil on the board surface, and PCB manufacturer should be use the position is exposed by black film, This applies to most PCB factories, especially
Electronics Forum | Sat Aug 22 10:25:11 EDT 1998 | Ben Salisbury
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo
Electronics Forum | Fri Feb 22 08:26:51 EST 2002 | davef
You are correct. The gold dissolves in the solder. The gold is meant to protect the nickel from oxidizing, so that you can solder to the nickel. Obviously that didn�t work as planned. Your background information is very sparse. Two things come
winsouce.jpg)
.png)
