Industry News | 2010-04-09 21:17:21.0
Five of Indium Corporation's technology experts will present their technical findings at APEX in Las Vegas, Nevada, April 6-9, 2010.
Industry News | 2008-02-06 18:44:36.0
EAST WINDSOR, CT � February 6, 2008 � Blue Thunder Technologies Inc., a manufacturer of high-quality wiping products and a supplier of consumable items used in cleanrooms, assembly lines, laboratories and manufacturing, announces that it has numerous ESD products available.
Industry News | 2021-12-13 20:23:11.0
During the use of your air compressor, there could be tricky oil separator burning failures. So this article will tell you the causes and solutions as well as some cases.
Electronics Forum | Mon Dec 30 12:36:20 EST 2019 | emeto
Thanks Rob, this is excelent
Electronics Forum | Tue Dec 31 02:10:54 EST 2019 | sssamw
The video showing wave contact is not consistent and not stable from width size, make it better.
Electronics Forum | Tue Dec 31 02:10:04 EST 2019 | sssamw
It looks like solder dross there or flux residue that not activated well. Your speed is 43cm/60s, wave width contact is 2cm, so dwell time is 2x43/60=1.43s, it's short also.
Electronics Forum | Fri Dec 27 12:12:29 EST 2019 | slthomas
As has already been mentioned, black residue is usually either from dross or just a dirty pot, pump, baffles, etc.. I also saw that maaaany years ago in a system that used a flawed oil intermix "feature" but hopefully those systems are long gone.
Electronics Forum | Sat Jan 18 12:44:35 EST 2020 | anteiv
We made much better contact of wave with board. There was not enough solder in bath. We increased it so wave height is higher with same pump power And now board is pushing dirty wave to the other side and board is much cleaner!
Electronics Forum | Fri Jun 08 18:27:03 EDT 2007 | jmelson
This is probably an inner plated layer of the component that did not bond well. It may be a component that either has the wrong surface finish for lead-free or can't handle the temperatures. Many times I have seen a similar-looking layer when the l
Electronics Forum | Fri Dec 27 02:11:31 EST 2019 | anteiv
Hello, We are having problems with SMD wave soldering (ERSA) used flux is BALVER ZINN 390-RX-HT https://www.balverzinn.com/tl_files/balverzinn/downloads/intern/TDB/PDS_390-RX-HT_EN.pdf https://www.balverzinn.com/tl_files/balverzinn/downloads/datenb
