Electronics Forum | Fri Dec 27 16:12:54 EST 2019 | anteiv
thank you for reply here is picture of the board https://imgur.com/a/i2MfFBw on the bottom are pins/components which height is about 3-4 mm from bottom of the board we had to increase distance of board from nozzle to make clearance and we increas
Electronics Forum | Tue Dec 31 02:33:57 EST 2019 | anteiv
thanks again for reply, we have now configured speed of traveling so pcb can travel through preheat with one speed (call it v1) and through wave with other speed (call it v2). Lenght of preheat elements is fixed, so with speed v1 we can change pr
Electronics Forum | Fri Dec 27 12:42:36 EST 2019 | rgduval
In your video, it looks to me as though the bottom of the glass is too low, but, I can't tell for certain. As a general rule, keep the top of the wave no higher than the mid-point of the PCB. Top flow will take care of itself thanks to flux and cap
Electronics Forum | Fri Dec 27 17:40:55 EST 2019 | rgduval
Using no-clean flux will make the boards very difficult to clean. If you can switch to water soluble flux, your life will be much easier. The "icicles" lead me to think that the board isn't getting hot enough in the pre-heat cycle, and/or there isn
Electronics Forum | Thu Mar 16 18:38:30 EST 2000 | cpgoh
Hi, I would appreciate some help here.. I am black residue with my wave soldering provess with my Electrovert machine sometimes, they are dotted all over the board ! I am also using no clean flux through an externel spry fluxer unit.. thanks Darren
Electronics Forum | Fri Mar 17 03:27:20 EST 2000 | Wolfgang Busko
Darren: Do you know what these residues are ? How clean is your solderbath ? How often during a day do you clean it ? My first impression is that you deal with oxides. M2C Wolfgang
Electronics Forum | Tue Apr 04 05:56:52 EDT 2000 | Wolfgang Busko
Sorry to hear that Electrovert isn�t much help in your situation but the manufacturer of a system should be the first source of information on the equipment regarding preventive maintenance and troubleshooting. You should try to get in touch with th
Electronics Forum | Fri Mar 17 21:44:14 EST 2000 | sosina_outry
Daren: suggestion from a friend of mine 1. Is residue on the top or bottom of the board? If on the bottom, then you might need to do solder dedross. if on the top, you might need to check 1. after spray flux, check for any excess flux on the top of
Electronics Forum | Mon Apr 03 01:17:37 EDT 2000 | cpgoh
I ever thot of changing the whole solder pot altogether but then it prove to be a costly measures.. If looking at the source of the problem, it might be mainly due to the way that the machine had been maintain... Anyone care to share how they are per