New Equipment | Assembly Services
One-stop PCB and Assembly Manufacturers Specialized in one-stop PCB and Assembly manufacturing, Heros Electronics is committed to providing quick-turn high quality custom PCB and smt assembly to our customers all over the world with affordable pri
New Equipment | Assembly Services
One-stop PCB and Assembly Manufacturers Specialized in one-stop PCB and Assembly manufacturing, Heros Electronics is committed to providing quick-turn high quality custom PCB and smt assembly to our customers all over the world with affordable pri
Industry News | 2018-10-18 11:08:03.0
Different Techniques for Plating
Industry News | 2018-11-27 14:03:14.0
Super PCB is pleased to announce that it offers a variety of quality PCB surface finishes. PCB surface finish is the coating between the PCB and components that provides a solderable surface for components and protects the exposed copper circuitry.
Industry News | 2019-05-16 01:27:23.0
There are several surface treatment for PCB board: bare board (no treatment on the surface), rosin board, OSP (Organic Solderability Preservatives), HASL (lead tin, lead-free tin), plating gold, immersion gold, etc., these are relatively conscious treatment. Many people can't tell the difference between plating gold and immersion gold, thinking that it is the same thing, it is a big mistake. The following is a brief introduction to the difference between plating gold and immersion gold.
Electronics Forum | Fri Sep 12 09:10:23 EDT 2003 | Norm Morikawa
Around 1989 I had this probelmm with a SMT CCA that would not solder in one area consistently. I had it cross sectioned by the bare board supplier and found that under their metallurgical microscope the thickness of this HASL bare board could not be
Electronics Forum | Tue Sep 09 18:07:18 EDT 2003 | davef
We would be very wary of allowing 50 uinches, because this will likely result in reduced shelf life due to intermetallic growth. As a guesstimate, at least 10 uinches of that 50 uinches, and maybe more, is already intermetallic when you receive the b
Electronics Forum | Wed Sep 10 12:56:09 EDT 2003 | davef
Intermetallic compounds [IMC]: * Form during the alloying process of some metals. In soldering these are Sn, Ni, Ag, Cu, Au. * Do not accept solder. * Increase in depth in logarithmic proportion to both time and temperature. [So during the solder
Electronics Forum | Thu Mar 02 13:04:22 EST 2006 | Chunks
0603 parts at .2mm spacing is pretty easy. But are there any other parts, like fine pitch QFPs? Is your board HASL or something else? Is there resist/mask between all pads? If it's just 0603's at .2mm, then you can probably go 7 mils and get good
Electronics Forum | Mon May 18 13:18:25 EDT 1998 | Chrys
I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered and soldera