Full Site - : board broken (Page 10 of 20)

question about reflow- it it ever a long term solution?

Electronics Forum | Tue Jul 03 16:15:08 EDT 2012 | kq702

Hi, when they did the reflow with the south bridge chipset they took a heat gun and went arround the chip in circles. This is what I did with the broken apple motherboard. I covered the board in tinfoil and cut out the squares arround the gpu, cpu an

Landrex Optima II AOI

Electronics Forum | Tue Nov 04 10:47:54 EST 2008 | rway

Thank you all for the great responses. We to looked at tne Mirtec before settling on the YesTech. I felt the machine software was better structured and organized and the system caught more faults on our "broken" board than the other system did (We

Wave Solder - solder bubbles/outgassing??

Electronics Forum | Tue Nov 14 18:38:59 EST 2006 | Brandon

Hello all, I am having an issue with some boards on our Wave Solder. It is a Pb free wave and These particular boards are exibiting A LOT of what I call solder bubbles in the larger than usual vias and un-used thru holes. Settings: 4 inch/min 144c to

Re: *****Update: Depanelization Troubles; Please Read*********

Electronics Forum | Thu Jun 18 22:25:24 EDT 1998 | Dave F

| | | | | We're running into problems with board damage (broken traces, solder shorts) due to pliers and other bizarre tools being used for depanelization. I need some sort of fixture for this. A delrin plate with a slot cut to the correct depth and

LED lifted soldering defect

Electronics Forum | Wed Dec 04 07:35:08 EST 2019 | proceng1

We also have a few customers that seem to buy the cheapest LEDs available and provide them for the build. We've had complete reels that had obviously been exposed and oxidized. You can try a solder with a more aggressive flux. How long is your pro

question about reflow- it it ever a long term solution?

Electronics Forum | Tue Jul 03 02:42:37 EDT 2012 | kq702

Hi I did a reflow on an HP laptop a while back- it was a DV6000 series. The original problem was the internet stopped working- turns out the south bridge chipset was causing the issue (its a very common issue I found out after searching online). Some

AMP Mictor

Electronics Forum | Wed Dec 05 18:22:14 EST 2001 | gbarrows

I assembly boards that have 200 each of the MICTOR connectors. The boards are .300" thick. I have 100% solder fill in the holes. I also have developed a rework process so I can remove and replace the connectors if the they get broken by my custome

Aqueous Board Cleaning

Electronics Forum | Sat May 24 00:43:59 EDT 2003 | iman

Our engineers did a study on our medical product with 1mils standoff height, and one issue was 100% of the boards that underwent ultrasonic failed due to failure of the package wirebonding. Poor reflow control would be one area to review in any event

Warming up solder paste at start of days production

Electronics Forum | Mon Jul 26 19:37:47 EDT 2004 | Grant

Hi, It was funny. The sight of 3 men standing around the microwave daring each other to push the start button, and then freaking out when the whole thing looked as though it was going to explode was funny. I guess you have to try these things! Tho

Missing component benchmarking

Electronics Forum | Thu Mar 14 17:28:35 EST 2002 | stepheno

I worked with Fuji CP6 where one of the techs wanted a minimum of part data's. He was used to working with panasonic machines. We would get resistors broken in two if the part data was too small and parts flying off the board if the part data was t


board broken searches for Companies, Equipment, Machines, Suppliers & Information