Electronics Forum | Tue Feb 23 14:21:17 EST 1999 | Mike McMonagle
| A rash of new products here at my company have designs with multi-pin connectors 90 out-of-phase (orientation)wiht respect to wave direction, which has lead to massive bridging (shorts) problems.... | | Does anyone still use the 45 Degree Pallet
Electronics Forum | Tue May 21 15:00:28 EDT 2019 | emeto
Hello Greg, Here are a few questions and advises that might post an answer: 1. How thick is your current stencil and what is the part that requires that thickness? 2. Can you use a carrier to keep your board straight and avoid board warpage? May
Electronics Forum | Sat May 09 11:54:12 EDT 1998 | Bob Willis
All the comments that have been made a great but I do have to say that much of the problem comes back to the design engineers not designing for manufacture. Centre board supports would have sorted the problem without jigs. | | I am running a board t
Electronics Forum | Thu May 07 12:54:01 EDT 1998 | DARRYL SCHLOSSER
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Fri May 08 08:12:32 EDT 1998 | Steve Gregory
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Thu May 07 13:22:37 EDT 1998 | Chrys
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Sat Dec 18 08:23:33 EST 2010 | remullis
I experienced warpage on a 7'x 13" long board, unfortunately my oven does not have center support. I use stiffeners on both of the short ends. It fixed my problem. Some of the things I was experiencing with the warpage on the second pass were placem
Electronics Forum | Wed Aug 09 09:25:57 EDT 2006 | Mike F
Am I missing something here? I usually put some type of stiffener or support on the leading edge to make sure the PWB doesn't sag in the middle from the preheat. If I had to add a bean bag with shotgun pellets or BB's I would have boards falling out
Electronics Forum | Wed Jul 21 11:12:05 EDT 2010 | remullis
I have some 13" long boards that warp considerably during first pass through reflow (no center support), what I've done to improve this type of warpage is stiffeners along the front and back edge. This may help with twisted boards as well.
Electronics Forum | Tue Jul 14 15:21:28 EDT 1998 | Brian Conner
| We are wave soldering a board having 24 similar thru hole connectors on it, using a wave soldering pallet. The problem is that one particular pin of connector in around 6-9 connectors get excess solder on the bottom side. I have tried all the par
