Electronics Forum | Mon Jan 21 09:29:33 EST 2013 | cnotebaert
I agree, you will likely need a carrier being that thin. without seeing the trace layout I’m not sure about relieving the carrier to accommodate them. if evenly distributed you shouldn’t to go that far. Are parts on both sides of the board? Don’t mak
Electronics Forum | Fri Jun 11 01:40:40 EDT 1999 | Gyver
| | | Hello all! | | | Recently we got a problem about the Funtional test. Some boards passed tests by using the auto-fixture(vacuum), but failed by using manual test fixture(need to plug CPU, DIMM etc.). The error symptom is no picture. We doubt it'
Electronics Forum | Thu Feb 27 12:27:10 EST 2003 | stevel
Hi all, We got some bare pwb in our incoming inspecion looked really wrapped. The maximum twist of the pwb we messured is 0.056inch by following the method in IPC-TM-650 2.4.22 C. (The diagonal size of our pwb is 7.5inch) According to the IPC standa
Electronics Forum | Fri Feb 28 09:08:03 EST 2003 | davef
Without drilling through the numbers, they're probably correct. Recognize that standard warp / twist specs [IPC-A-610 1.5% for PTH only and 0.75% for SMT] are not going to make it on tech boards. You need to define specific requirements. This warp
Electronics Forum | Wed Jul 21 20:52:52 EDT 1999 | Scott
| | I have pcb's in which i am experiencing warping. | | the boards are 12.8125" on a diagonal measurement. | | they are out approximatley .010". | | the boards are combination thru-hole,smt, they also have 3ounce copper.what is acceptable,and what i
Electronics Forum | Thu Jul 22 06:54:45 EDT 1999 | Earl Moon
| | | I have pcb's in which i am experiencing warping. | | | the boards are 12.8125" on a diagonal measurement. | | | they are out approximatley .010". | | | the boards are combination thru-hole,smt, they also have 3ounce copper.what is acceptable,an
Electronics Forum | Wed Aug 19 12:20:24 EDT 1998 | MARK J.
| Hi there, | I'm actually facing a lot of trouble with PCB's presenting up to 3mm of bow /twist at reception i.e. before assembly. The PCB size is 220 by 230mm. The boards are to be assembeled SMD double sides with 05.mm pitch on both sides. In orde
Electronics Forum | Sat Nov 18 21:20:58 EST 2006 | Fer
Dave, May I ask where did you find the 1.5%, or the goal of .005" (or .007") per inch? The IPC-A-600 bow and twist standard calls for a .75% based on the calculation of the test method TM-650, method 2.4.22, which calculates the percentage based on
Electronics Forum | Wed Jul 12 05:04:01 EDT 2000 | JohnW
Hi Guy's.... Was thinkng about i more this moning..in the shower actually...sometimes think I do my best work there!. So far I'm looking at stuff like integrating the DFM study to show thing's that are going to present production / process issues e
Electronics Forum | Wed Jul 21 13:12:11 EDT 1999 | John Thorup
| I have pcb's in which i am experiencing warping. | the boards are 12.8125" on a diagonal measurement. | they are out approximatley .010". | the boards are combination thru-hole,smt, they also have 3ounce copper.what is acceptable,and what is the pr
