Industry News | 2012-02-15 19:34:02.0
April 25, 2012 will witness the opening of NEPCON China 2012 at Shanghai World Expo Exhibition & Convention Center. As the largest event for the electronics manufacturing and SMT industry across Asia, NEPCON China has become the weather vane for China’s industrial peers. Currently, 98% of booths for NEPCON China 2012 are sold out with almost all the world-leading SMT manufacturers and material suppliers scheduled to exhibit.
Used SMT Equipment | Turnkey Lines
Functional Pre-Owned Complete SMT Assembly Line - Still Operational (Subject to prior sell, I am listing this on other venues) Up for sale is a full turnkey SMT line and all of it's accessories, of which there are a lot, fe
Electronics Forum | Tue Oct 02 07:48:16 EDT 2007 | brendansales
Hi there, Does your computer has a product key (USB) by any chance? there are some units that requires a USB key. alternatively you can check if the controller has been opened before (you can check if the sticker has been torn), or you can try swit
Electronics Forum | Tue Jun 07 05:15:45 EDT 2005 | blueflag
Help Please could anyone advise when we run shutdown after 45 mins it should shut off . But we are still left with conveyor running also fans . regards Colin
Electronics Forum | Tue Jun 07 22:01:56 EDT 2005 | KEN
run shutdown.rcp after 45 minutes computer will load shutoff.rcp. Is this file not being loaded? If yes, then you have not defined the shutoff event in the scheduler. Poke around in the scheduler. Or check out the software manual. someone probab
Electronics Forum | Tue Oct 02 20:26:18 EDT 2007 | marcelll
Thanks for the help guys. I found that serial port 2 was bad on the computer. Not able to change it to com 1 in the config. Seems to be protected by a factory password. So I had to change the computer and reload the software. It's working now. Thank
Electronics Forum | Mon Oct 01 19:44:49 EDT 2007 | marcelll
Just bought a used VIP 98 and I have an alarm. Computer don't communicate with the embedded controler of the oven. I've check the cabling, OK, and there's power on the controler. The PC is booting normally. The controler is plug in the serial port 2
Electronics Forum | Tue Oct 02 10:01:15 EDT 2007 | chrisgriffin
I once had a similar problem on a VIP98. The problem was with the FCU (furnace control unit). There was a burned IC on the lower left of the card. I don't remember what kind of part it was, only that it was very common and I got a new one from Dig
Electronics Forum | Mon Dec 17 12:12:18 EST 2007 | Claude_Couture
in very rare occasion I had problems with BTU ovens, I contacted BTU directly and they were always helpful.
Electronics Forum | Wed Feb 15 14:25:34 EST 2017 | eslavine
Hello. Just called btu and they recommend BIRAL BIO-30. Couldn't find any distributor in Canada. Do you know any equivalent? Thanks
