Industry News | 2015-06-01 12:17:17.0
NEPCON China 2015 took place at the Shanghai Expo Center from 21 to 23 April 2015. The three-day event, an annual industry highlight, was a complete success, bringing together nearly 22,000 trade visitors and high quality buyers, as well as 450 leading brand names from 22 countries and regions worldwide.
Electronics Forum | Thu Jun 30 08:00:07 EDT 2005 | Nirmal
pls check at rear side is there any relay spark or else check the connection between the monitor and the control card
Electronics Forum | Tue Sep 20 03:22:39 EDT 2005 | ajay
thanks, it was 15v power supply that was giving problem. ajay
Electronics Forum | Tue Jun 28 00:11:44 EDT 2005 | ajaydoshi
We do have BTU 150 Paragon oven. Link fail problem occume most of the time during start of day or after Sunday. It never haven while running continiously, Any Suggestion. Ajay
Electronics Forum | Sun Sep 18 20:42:37 EDT 2005 | Ken
Link Fail is the RS232 connection to the FCU. I would check the connector, cable that plugs into the computer. Verify all power supplies are working. The most likely scenario is this: Computer malfunction Cable / connector issue. Defecive FCU
Electronics Forum | Thu Jun 30 18:31:28 EDT 2005 | KEN
Make sure your RS232 is screwed in and not loose. Verify your PC is not hanging up and locking up the com port (windows can really suck some times). I would scan-disk and defrag. I bet its not a furnace problem, but a PC problem.
Electronics Forum | Fri Sep 16 16:22:51 EDT 2005 | JW
Sounds similar to a recent problem with our VIP70. We thought it may be the SSR, then the FCU ... Swapping blower unit with a second oven finally helped us traced the problem to the thermoswitch inside the blower assembly.
Electronics Forum | Mon Sep 19 04:27:47 EDT 2005 | dougs
Check your power supplies, we had same fail a while back on VIP98 faulty power supply was the cause
Electronics Forum | Fri Sep 16 06:34:07 EDT 2005 | ajay
We have link fail issue now & could not able to establish. Overall situstion is that oven can not work. we checked all relay 24vac, 24vdc, 110v, 120v, 240v. all looks ok. only issue we ovserve that from B250SSR pin no 3&4 we are unable to get 5VDC. T
Electronics Forum | Thu Aug 08 01:13:46 EDT 2019 | ameenullakhan
Thanks a lot everyone. For the valuable knowledge sharing. And technical links. ( will go through it ) We have BTU oven ( Pyramax X 150N ). Regards, Ameen
