Electronics Forum | Thu Oct 20 05:30:23 EDT 2005 | Slaine
Ive a 5 zone BTU vip 90 thats about 12 years old, and just lately its been a pain, its needed justabout all the fans replacing, the belt has eaten away the drive sprockets (they were fine a month ago) and just lately the belt speed has started to va
Electronics Forum | Mon Nov 13 13:27:51 EST 2006 | Javier
It really depends on what deliverables BTU can offer and successfully accomplish without the complexity of various reinvention activities. The basis of its� vehicle stability as a total platform should be broken into a framework of goals and objecti
Electronics Forum | Tue Jun 10 18:48:42 EDT 2008 | mefloump
We run 2 lines: Line 1 has a Dek 265, GL5, CP43, QP242E, and Heller 1900W; Line 2 has an Ekra X4, GL541, CP643E, QP242E, and BTU VIP98N oven. Soon both lines will have new Ekra X5 screen printers and the BTU replaced with another Heller. Works for us
Electronics Forum | Wed Nov 02 16:36:05 EDT 2016 | ttheis
Problem was bad FCU board; replaced with FCU from another machine and swapped rom chips. Oven operates properly and communicates with PC. BTU was kind enough to supply the default usernames and passwords for wincon but they did not work. Still waiti
Electronics Forum | Mon Oct 17 09:53:58 EDT 2005 | rlackey
BTU have been around since the start of SMT, with ancient TRS14's still running today with no problems, and bucket loads of VIP's, Paragons & Pyramax's doing good service. Wouldn't use anyhting else (Did like the new Vitronics-Soltec, but couldn't b
Electronics Forum | Sun Nov 12 21:18:31 EST 2006 | fastek
Kris- You obviously need to become more self-sufficient if you are struggling to keep your reflow oven up and running. Reflow ovens are too simple to repair to get freaked out over them. It's not always the vendor's fault when the customer doesn
Electronics Forum | Mon Dec 25 12:17:57 EST 2006 | KEN
first, does the recipe have the heat and conveyor boxes checked? If no then it does nothing. second, have you pressed the round green switch? third, are there any alarms in the alarm box? Do you have a controller link fail? Verify the cable is p
Electronics Forum | Sat Dec 30 00:02:10 EST 2006 | Mats
Hi, A couple of another things is to check: * The cooling water supply (assuming that your oven has this feature). * The fans (Just open the hood and check if every fan, up & down is running). * Open the back panels: and you should see some "black"
Electronics Forum | Thu Jan 04 04:49:51 EST 2007 | geb
Thanks, Chunks. Your first post was correct, it turned out to be the battery. That is that problem solved. Unfortunately I have now got an error message saying Flux Management Failure. Is this just a coincidence? It sounds like something to do with t
Electronics Forum | Mon Sep 13 15:47:44 EDT 2010 | dox
Somebody pressed the system set button and now the machine has an e-stop,lid open, and extraction error. checked the control relays and all is OK except one is not switching on. The cable comes from the FCU unit so suspect some config or settings are
