Electronics Forum | Mon Jun 26 04:41:06 EDT 2006 | dallen
Thanks for all the responses. BTU has now informed that the reason it is so expensive is the oven heaters need completely rewiring and some work in the transformer area etc is required. Also, we have to pay for engineering work for them to know wha
Electronics Forum | Mon Nov 13 04:30:16 EST 2006 | Loco
:o You wouldnt happen to have shares at BTU, Fastek? What you are replying is just what Kris was talking about. I wouldnt take it either. Customer service should be very important for any company. Imagine a broken oven, company coming to a stand
Electronics Forum | Wed Dec 27 10:55:47 EST 2006 | SWAG
I don't know much about BTU but we had a very similar problem with a Conceptronics and it turned out to be one of the 120V power supplies. Our machine had two of them (the same as you would find in any PC). Easy to test them although they can be fl
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
Electronics Forum | Sat Nov 11 21:00:10 EST 2006 | Kris
BTU - "WTF" We don't like them at all. We have no problem to set the profiles, it is a matter of fact that they are just perfect for that. The boards are just perfectly soldered. But - the their support sucks Big time! Or the lack of support! We are
Electronics Forum | Fri Feb 25 16:16:01 EST 2005 | pjc
Here are some 5 zones models to look for: Electrovert OmniFlo5 Conceptronic HVA70 BTU VIP70 Vitronics SMR or XPM 520 Heller 1088 (4 zone)
Electronics Forum | Thu May 26 21:07:22 EDT 2005 | KEN
This is caused by cte mis-match. The balls in the corners are short and fat. The balls near the null point are tall and more normalized. I don't remember what the zone settings were... BTU VIP98 BS was probably 22-25 IPM
Electronics Forum | Tue Jun 07 05:15:45 EDT 2005 | blueflag
Help Please could anyone advise when we run shutdown after 45 mins it should shut off . But we are still left with conveyor running also fans . regards Colin
Electronics Forum | Tue Jun 07 22:01:56 EDT 2005 | KEN
run shutdown.rcp after 45 minutes computer will load shutoff.rcp. Is this file not being loaded? If yes, then you have not defined the shutoff event in the scheduler. Poke around in the scheduler. Or check out the software manual. someone probab
Electronics Forum | Fri Sep 16 16:22:51 EDT 2005 | JW
Sounds similar to a recent problem with our VIP70. We thought it may be the SSR, then the FCU ... Swapping blower unit with a second oven finally helped us traced the problem to the thermoswitch inside the blower assembly.
