Electronics Forum | Mon Mar 27 15:10:48 EST 2006 | ms
Hi Steve Thanks for your reply. Your comments make it sound like it may be the nature of this paste. Any one else agree? Paste control is fairly good. Paste is put in fridge straight after it arrives at inwards goods, (4deg). Removed from fridge
Electronics Forum | Tue Sep 20 11:28:20 EDT 2011 | russw
We've got a Novastar 12S wave solder machine and we've been using Kester 951 flux for years with no problems. We just got a new bottle of 951 and it does not foam correctly (thin foam with lots of large bubbles). After a lot of back and forth with
Electronics Forum | Tue Feb 01 07:50:25 EST 2000 | Jason Bentley
This all depends on the mixture of your solder. If you are using water soluable flux then it will get clean. But not alcohol based flux. As for using the ultrasonic this might be a problem I personally have never heard of someone washing a board in a
Electronics Forum | Tue Sep 20 11:59:06 EDT 2011 | SheanDalton
Check specific gravity: According to a quick web search, the specific gravity should be 0.813 ± 0.003. If you have records of the specific gravity, compare current reading to past readings. Check pressure near stone: if you have records, compare
Electronics Forum | Thu Mar 30 21:46:56 EST 2000 | Dave F
Reg: This is copy / paste from draft version of IPC 7095 ( issued May 1999 ) ... 7.3 Assembly accept/reject criteria 7.3.1 Voids in solder joint a. Sources of Voids There can be voids in solder balls, or at the solder joints to the BGA, or at the so
Electronics Forum | Tue Jul 06 14:23:27 EDT 1999 | Earl Moon
| | | I've heard that use of VOC free flux with wavesolder fixtures can be challenging due to entrapment of water in the fixture. | | | | | | Is anyone out there successfully running VOC free with wave fixtures & did you experience problems? If so,
Electronics Forum | Wed Mar 25 19:41:01 EST 1998 | Earl Moon
| We have successfully put .016" vias in .030" pads. | There is no drain off with .030" solder balls, since | the actual volume in the .002" depression is low. | We did notice random bubbles where, apparently, the | solder reflowed and trapped the a
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
.png)
