Electronics Forum | Tue Jul 13 14:36:55 EDT 1999 | JohnW
| I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick. |
Electronics Forum | Mon Nov 13 20:55:11 EST 2000 | Dave F
Not too much to go on, bud. Tell us about: * Wire material, finish, insultation, etc * Wetting problem description * Why feed that the wire is used for through is important * Range and extent of the problem * Results of metallographic analysis of "g
Electronics Forum | Mon Jan 04 18:41:56 EST 1999 | Wayne
| If passive componets are cheaper why aren't they more popular? Manufacturers like Murata and AVX claim availability and substantial cost savings but little interest seems to exist. Why? Your input is greatly appreciated. | Because people just do
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 09:56:54 EDT 1999 | Wolfgang Busko
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Wed Jul 14 19:09:54 EDT 1999 | JohnW
| | | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stic
Electronics Forum | Sat Feb 22 11:27:16 EST 2003 | stefwitt
In the early days of SMT we were using vibratory bulk feeders for chip components. It was quite obvious that some of the components had to try several times getting through the gravity trap or with the right side up through the light sensor. As a res
Electronics Forum | Thu Mar 01 10:10:30 EST 2001 | Stefan Witte
Angela, besides the sense or non sense of six sigma and related meetings, you will have to break down the component feeding issue into several sections, which are all impacting the feeding reliability. 1. Component dimensions 2. Tape size 8, 12, 16
