Industry News | 2021-05-19 22:36:33.0
Calibration is the process of configuring an instrument to provide a result for a sample within an acceptable range. This process eliminated or minimized factors that cause inaccurate measurements. Although the exact procedure may vary from product to product, the calibration process generally involves using calibration instrument to test samples of one or more known values called "calibrators". The results are then used to establish a relationship between the measurement technique used by the instrument and the known values. The process in essence "teaches" the instrument to produce results that are more accurate than those that occur otherwise. The instrument can then provide more accurate results when samples of unknown values are tested in the normal usage of the product.
Industry News | 2008-03-01 20:28:20.0
January 2008 - EVS International, the leader in solder recovery, announces that it will introduce the EVS 7000 and EVS 9000 solder recovery systems in distributor Sono-Tek�s booth 263 at the upcoming APEX 2008 exhibition and conference, scheduled to take place April 1-3, 2008, in Las Vegas. The new systems replace the popular EVS 3000 and EVS 6000 machines which are market leaders in solder recovery.
Industry News | 2015-10-21 20:30:02.0
Gen3 Systems Limited is pleased to introduce a totally new design of the Contaminometer (CM Series Process Ionic Contamination Testers) it will be released in Hall A4, Booth 470 at the productronica International Trade Fair, scheduled to take place Nov. 10-13, 2015 at the Messe München exhibition center in Munich, Germany. Gen3 will be exhibiting alongside its German Distributor, Stannol GmbH.
Industry News | 2013-05-28 14:30:51.0
A traceability solution should be able to assign assembly data to products without any doubt. Many systems, however, are likely to fail if there is manual intervention. Essemtec has now invented the integrated PCB identification system that no longer can be bypassed.
Industry News | 2013-08-13 12:54:43.0
The market requires highest flexibility from electronics manufacturers.
Electronics Forum | Wed Mar 14 00:44:22 EDT 2007 | Yngwie
Thanks for the reply Dave. :) No, we dont toss in 500g on the stencil. Have you heard of any method to convert the solder paste to solder bar, just in case someone have done that before? Thanks.
Electronics Forum | Mon Mar 05 11:04:14 EST 2007 | Yngwie
We are exploring ways to reduce the waste of solder paste. Here are some of the ideas I have in mind: 1) To use paste supplied in Syringe instead of jar. Paste that are opened more than 8 hours will normally be discarded, so we are looking for ways
Electronics Forum | Fri Aug 18 05:43:51 EDT 2000 | Richard Berry
Thanks Wolfgang / Charles Have tried method suggested by Wolfgang on one product, and seem to be a bit over (perhaps density calculation was a bit out). Also, the volume of paste deposited must be less than the voume of the apetures on the stencil b
Electronics Forum | Wed Jan 14 08:24:07 EST 1998 | Allison
Good luck in your conquest. I have been struggling with the same issues for some time now. I have made the following conclusions. First, it is nearly impossible to establish parameters in SMT to perform X-Bar and R charts. Electronics is not as cl
Electronics Forum | Tue Dec 12 13:33:52 EST 2000 | justin medernach
Dross removal is dependent upon the "activity" in your solder pot and the usage of a inert or an "air" atmosphere. The more moving that agitate the solder, the more dross. Basics first and then the answers will make sense. What is dross? Oxidatio
