Electronics Forum | Thu Jul 20 16:10:34 EDT 2000 | armintan
Hi Bob, From my memory about almost 4 yrs. ago, I remember we did something similar to this in Apple Computer Singapore. Process sequence are: Bottom Side Process: Print Solder Paste(Dek 265GS) Dispence Adhesive (Cam/Alot 3800) Place Components (
Electronics Forum | Thu Jun 29 12:36:10 EDT 2000 | Gary
You might try your search with the words Adhesive Dispenser. We recently evaluated machines from Asymtek, a Nordon company, Camalot, and Zmation, and GPD. There are several others. One consideration in the scenario you described is to make sure th
Electronics Forum | Thu Dec 11 04:25:06 EST 2008 | lconnor
I have previously experienced dispensing glue dots using a camalot system. This was used to dispense dots for a variety of components, as the SMT was applied post through hole and then wave soldered. No paste was used in the process. The other benefi
Electronics Forum | Wed May 10 19:58:19 EDT 2000 | Steven J Adamson
Hi Stuart, just to be clear right from the start I work for Asymtek, so you know where this reply is comming from. I agree with Jax and Micah that to purchase Fuji or Camalot will probably be a system that you are more familar with, so the learning
Electronics Forum | Tue May 15 10:02:20 EDT 2001 | John
I should have been more clear;the temperature that I indicated was measured inside the dispenser cabinet. We setup a very simple system to monitor and maintain the temperature inside the cabinet. By comparing our temperature to our production resul
Electronics Forum | Fri Mar 19 13:26:19 EST 1999 | Scott Cook
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Mon Oct 14 12:56:50 EDT 2002 | davef
His technical contribution to the forum. From these 24 postings, we can see that 75% of Sean�s postings have a decided commercial bent, as followings: * Could be argued that the posting is a good technical response. Percent of postings 25%. * Could
Career Center | Poway, California USA | Engineering,Production
Technically qualified in proper operation, troubleshooting, installation /dismantling, programming and preventive maintenance of SMT (Surface Mount Technology) machines. Productivity and quality for the production of PCBA (Printed Circuit Board Ass
Career Center | Cavite, Philippines | Engineering,Technical Support
I had 15 years Handling SMT Equipment.