Industry News | 2017-01-11 17:39:59.0
ViTrox Technologies today announced plans to bring its new product line to the IPC APEX EXPO, scheduled to take place Feb. 14-16, 2017. During the show, ViTrox will have live demonstrations of its ONE-STOP solution in Booth #2823, from the V510i XXL to V810i S2EX In-Line Advanced 3D X-Ray Inspection System by connecting with the first ever software-based product, V-ONE!
Industry News | 2010-12-07 15:01:55.0
NEPCON China 2011 will be held in Shanghai Everbright Convention & Exhibition Center from May 11th to May 13th, 2011. To date 90% of the booths have already been sold, a strong indication of the trust and confidence in the NEPCON brand and represents further confirmation that NEPCON China is a leading international electronic manufacturing feast in China
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
Electronics Forum | Fri Feb 23 07:58:27 EST 2007 | realchunks
Does your camera / stopper move to a spot where it can catch the boad when the middle sensor is triggered? It sounds like you may have your board stop coordinates wrong. Check your X measurement to be sure.
Electronics Forum | Thu Feb 22 20:17:34 EST 2007 | dekhead
My guess from your description is that you're talking about the board at stop sensor (mounted on camera) that is seeing the board, but the board edge is not hitting the stopper. Either the board stop is not extending fully, or the board is sagging an
Electronics Forum | Mon Feb 26 12:10:24 EST 2007 | JCB
As you are running Left to Right it is the trailing edge of the board leaving the board at left opto that tells the board stop to lower (not the sensor under the camera - that just confirms the board has arrived at the board stop). How big is the boa
Electronics Forum | Mon May 16 13:15:16 EDT 2022 | richardcargill
The camera crashing is usually a fault with the encoder on the Y motor assembly. someething to do with not finding a home pulse I think. Anyway, replace the motor/encoder and recalibrate and you should be good to go
