Electronics Forum | Wed Jan 21 12:25:45 EST 2015 | dyoungquist
Kester makes a thermocouple solder: Alloy SN10PB88AG2 Flux "44" Core 58 Diam 0.031" I have used this to solder thermocouples to pcbs when profiling for lead-free temperatures. When done you can unsolder the thermocouple and reuse it again. This g
Electronics Forum | Thu Aug 07 16:00:02 EDT 2003 | caldon
Yes you are correct Barry. The Suction tape provides a flat surface for the PNP nozzle to pick -up. In some cases I have seen a plastic "cap" ove rthe pins to provide the same thing. The cap can be reused. Both require, unfortunatly, manual removal
Electronics Forum | Tue Oct 12 07:19:56 EDT 1999 | D Scott
| Do anyone know what is TCP. I was told it is tape carrier package but have found nothing relating to this. Could someone please explain the whole tecnology and point to site relating to this so that i can understand more on this. | I would star
Electronics Forum | Fri Jul 21 15:26:59 EDT 2000 | Boca
You're going in the direction of fab improvement, a great direction. But in another direction; If you're already in a carrier, how about using a skyhook of some sort to support the middle of the fab from the top side? In some cases you can put fine
Electronics Forum | Wed Jul 17 11:26:19 EDT 2013 | pbarton
What equipment do you have? As well as the comments from others, another major influencing factor can be the residual heat in your PCB carrier. It takes more heat energy to warm a cold carrier than if it is already hot from the last cycle run. This
Electronics Forum | Sat Oct 27 14:57:00 EDT 2018 | jacobidiego
Hi Experts, I have noted a savings opportunity on our work-place as chipmounters discard carrier tapes which are easily separated in different waste-containers below the feeders. Normally the company pays a service to dispose that waste. Have anyon
Electronics Forum | Thu Jun 09 13:30:34 EDT 2005 | PWH
I would suggest 7mm thick "Durostone" as a carrier material. Cut lip/pocket for PCB so it is 0.05" thinner than thickness of PCB. Allow 0.010" gap on all sides of PCB. Machine lip to width between 0.050" and 0.100" to support under perimeter sides
Electronics Forum | Fri Dec 10 09:32:04 EST 1999 | Dave F
Joe: It might be tough to generalize about the number of times you can reform a lead before it is weakened beyond the point of reuse, because of different lead materials, thicknesses, amount of bending etc. It might be that "ugliness" is the answer
Electronics Forum | Thu Jun 04 10:00:11 EDT 1998 | Dave F
| Looking for vendors of splicing tape for 8,12 and 16mm tape and reel. | Any net sources? If you can use carrier (cover) tapes go see "Igmar Grewar 16:04:32 5/28/98" on SMTNet. Dave F
Electronics Forum | Wed Sep 10 11:57:14 EDT 2003 | Mike Konrad
First, you must determine a few things: 1. What specific de-fluxing chemical are you going to use? Basic required determinations include the chemical�s pH, is it a VOC (if so, what is its VOC content), what concentration is the chemical used in (1