Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Thu Apr 07 08:02:44 EDT 2005 | Grant
Hi, I used to run a clean room, and it's right, most of the dust is created internally. You will need to add some HEPA filtering to the area, and an air handling unit that can control temp and humidity as well to get correct environmental control.
Electronics Forum | Tue Sep 19 09:41:30 EDT 2017 | sumote
Steve, The 4 things I would do, and in this order: 1. Clean your stencil with stencil cleaner wipes after it comes out of the stencil cleaner. I like MicroCare ProClean (MCC-PROWR). I will even saturate the wipe with a bit of isopropal just till