Electronics Forum | Wed May 06 20:52:26 EDT 2015 | arbpkevin
I have been using my topaz X for about 4 years now and I feel that I am fairly knowledgeable about it, at least the functions of it that I use... I am trying to use the LCS to place some qfp chips on a new product and I have set the whole thing up t
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Mon Jul 25 17:27:45 EDT 2016 | victoriajon
Up and running smoothly this morning, but got the attached error when switching from a reel feeder to a tray of the same part. We are getting this error message during setup - any suggestions are welcome. I am available to answer any questions that
Electronics Forum | Thu Aug 04 15:07:30 EDT 2016 | sumote
I have seen a similar error on a Quad 4C machine. When setting up the parameters on a tray part there are several points of data you have to input. You have to teach where the center of the 1st part (and you have to know which corner your machine con
Electronics Forum | Thu Jan 11 19:52:55 EST 2024 | travishemen
Check the top of the placing head. There are 3 screws around a piece that pops up when you push up on the nozzle. I had one once that was vibrating and causing the part to place slightly off angle. It is exposed to the vacuum used to pick the part
Electronics Forum | Thu Aug 25 08:22:41 EDT 2016 | bobpan
If I have to guess then I would say the machine is first picking up a larger nozzle to pick up this part.....the nozzle is not seating on the z-rod correctly and causing a problem. Check to make sure the nozzle is being mounted correctly. You may als
Electronics Forum | Mon Apr 08 15:07:56 EDT 2024 | tey422
To me, it seems like there are slightly XY offset. Hydra might be able to pick up the tips, but not all the way securely attached to the hydra tubes. So, when the tips put back are not fully seated, which causing the tool stick inside the bank. You
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Thu Oct 26 13:56:08 EDT 2000 | ptvianc
Hello: Pre-baking laminates should only be performed:(1) to meet contractual agreements or (2) in response to an actual defect that can be traced to PWB water absortion. Besides the fact that a pre-bake is an enormous process "bottleneck," it also
Electronics Forum | Tue Oct 16 10:06:46 EDT 2012 | jackofallmasterofnone
Hello all, First off let me start by introducing myself. My name is Dan and I work for a contract manufacturer. During a job search I had heard from a previous co-worker that there was a packing job available at the facility where he now worked. I
