Electronics Forum | Fri May 15 11:59:05 EDT 2020 | stephendo
There are a couple of other countries that should be on your list to considered in at least some circumstances. Canada and The United States. I work for a CEM in Toronto, at the end of last year before all this, we had a largish job for a customer i
Electronics Forum | Mon Oct 11 13:44:29 EDT 1999 | Dave F
Ken: Since Earl is no longer here, I guess I'll bite on this. Your questions are very broad and difficult to answer specifically. So, I'll give you broad and non-specific answers. | Hi, | | We are using mixed technology in our PCBA. Would like to
Electronics Forum | Mon Jan 22 15:51:46 EST 2001 | aiscorp
TransCollaborative Manufacturing software (TCM) is involved in virtually all events flowing from receipt of CAD and BOM data, to procurement of components, to conversion into useful information, and finally to the production of actual product Consid
Electronics Forum | Fri Nov 20 08:23:13 EST 2009 | jeffreyj
MikeS - Thanks for the tips. Coombs book has been on my "to buy" list for awhile now... Guess I better buck-up and get it. EMPF is an old gem, for sure, but one I had forgotten about, so thanks for that reminder. I couldn't find the SMT 101 guide at
Electronics Forum | Tue Dec 05 21:11:35 EST 2000 | Dave F
The CDROM player in my personal computer just died and I replaced it with a more lively unit. Being an inveterate gearhead, of course I had to field strip the old CDROM player as soon as I pulled from my PC [and got the new one running]. There are
Electronics Forum | Sun Aug 06 16:37:00 EDT 2000 | fraser
1. A step stencil is a waste of perfectly good stainless steel! 2. They are characterised by lousy prints on the very parts that are most critical in your process - whilst leaving good prints on the easy stuff. 3. MMM.... nasty chemicals! 4. Exactly!
Electronics Forum | Fri Jan 21 19:27:54 EST 2000 | Scott S. Snider
With the Siemens line computer it is possible to see what the maximum placements per hours should be for any given job/setup. After you optimize the job you should check that and see how you perform against that number. In many cases the placements
Electronics Forum | Mon Jun 07 07:31:59 EDT 1999 | tannlin
| Hi everybody, | | Somebody know the advantages of electroformed stencils on laser cut stencils ? | | any coment is apreciated. | | | thanks | | Al Al I have a quote for you from one of the major CEM's "anyone who thinks they are controllin
Electronics Forum | Sat Aug 22 10:25:11 EDT 1998 | Ben Salisbury
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo
Electronics Forum | Tue Aug 25 12:50:24 EDT 1998 | Lance Smalley
To see if the MV will recognize the marks, in the binary mode, when setting threshold (binary level), raise up the level until the edge of the mark starts to degrade. Write down the number. Lower the level until the fiducial starts to "bloom". Wri
