Electronics Forum | Wed Aug 15 16:14:22 EDT 2001 | davef
Comparative Tracking Index [CTI]. In printed circuit board fabrication, CTI is a measure of the ability of the laminate surface to withstand tracking [carbonneous tracks on the surface, under wet contaminated conditions] across two electrodes placed
Electronics Forum | Fri Oct 05 07:46:24 EDT 2001 | george
Specifications of testing force are not fixed, but (incase of wave soldering) the value should be at least 120-150 % of the force the wave. So for small chip components we assume that the force from the wave on the component is about 3 Newton, this m
Electronics Forum | Tue Jan 29 20:14:54 EST 2002 | davef
Please help us understand your situation better by describing the following: * Component [ie, PTH/SMT, type of component, lead finish you expected/ received, etc.] * Board type [ie, type of board FR-4/CEM/ceramic, etc.] * Solderability protection on
Electronics Forum | Tue Jul 01 18:36:06 EDT 2003 | Matt Kehoe
I am trying to get opinions about a situation that we are discussing with a vendor/customer. While not a technical issue it has caused some confusion and I need some opinions to help settle the debate. We are a service bureau who receives stencil fi
Electronics Forum | Fri Jul 04 21:09:04 EDT 2003 | ramanandkini
I have a CEM-1 PCB board with 35 microns copper. This is PCB is finished with SMOBC+HALS. We do solder SMT LEDs, but till date we do not have problems that you have listed. The LEDs are good & bright. It even passed high & low temp cycle tests (-40 t
Electronics Forum | Thu May 12 04:37:30 EDT 2005 | Rob
1) Only if it's a real enhancement, and not to fix a fault in your design. 2) No, it just has to be instinctive & accurate. 3) Barcode is fine by me, but others swear by data matrix 4) Better than 1 in 10,000 - which could be once every 5 boards.
Electronics Forum | Wed Oct 26 06:36:33 EDT 2005 | rlackey
Hi Ken, We would build a one off with an exact number of components on a different line, in a different manor completely to a volume, chipshooter job - however, we'd only really be doing a one off like that if it was a prototype as we're not in that
Electronics Forum | Thu Feb 16 13:06:49 EST 2006 | masrimhd
Hello, We�ve ordered the line machinery for our TV factory. It should be ready after two to three months. We will start producing Analog CRT TVs using single sided FR2 or CEM1, thru-hole components and tin-lead wave soldering process. Knowing that
Electronics Forum | Sun Jan 28 13:26:27 EST 2007 | Sweet Old Bob
Okay you CM haters I don't see anything about the design of the board, other than OSP which is strike one. What is the board size? What is the board thickness? Where is the BGA located on the board? What is your ball to pad ratio? What is your aspect
Electronics Forum | Mon Jan 29 16:04:29 EST 2007 | BillW
Thanks Russ and John, To clarify defects when manufacturing a PCBA, I use (2) groups of defect categories, one for components and one for solder joints. These can be calculated separately or combined A component defect could be: Missing, Miss-alig
.jpg)
