Industry News | 2017-10-17 19:47:15.0
Nordson DAGE, Nordson MATRIX, and Nordson YESTECH, divisions of Nordson Corporation (NASDAQ: NDSN), will exhibit in Hall A2 Booth 445 at productronica 2017, scheduled to take place Nov. 14-17, 2017 at the Messe München in Germany.
Industry News | 2008-08-25 22:10:14.0
While many smaller EMS providers are struggling in North America, Abenex is marching to its own beat�and doubling revenues in 2008.
Used SMT Equipment | Turnkey Lines
Functional Pre-Owned Complete SMT Assembly Line - Still Operational (Subject to prior sell, I am listing this on other venues) Up for sale is a full turnkey SMT line and all of it's accessories, of which there are a lot, fe
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Thu Dec 31 12:32:29 EST 2009 | vetteboy86
Thank you very much for the input. I figured out my problem to be that once I defined the tray, I did not changeover the table top just as Bob said. I'm good to go now, I think anyways. I was so used to the IQ feeders, changing over the matrix tray
Electronics Forum | Wed Dec 30 15:05:18 EST 2009 | bobpan
Craig: Make sure you have done a table changeover and then when you go into teach tabletop there should be a tab at the top that says matrix trays. After selecting that ...choose the tray you want below and then right click on a part on the tray in t
Electronics Forum | Fri Apr 07 16:12:37 EDT 2006 | craig_83
I would like to freeze feeders on a global basis. I am tired of table changeovers everytime I run a different board. A good example is today I ran 1 board which went well. I wanted to run a board behind it that had 99% the same parts. I am not necess
Electronics Forum | Fri May 16 12:14:04 EDT 2003 | pjc
The UIC HSP (Sanyo), like Panasonic MV MS and Fuji CP, are random access turret type chip-shooters. Having a split carriage, typically 2x 60, 2x 70 or 2x 80 input carriage tables, allows for faster changeovers provided you have enough positions on ea
Electronics Forum | Thu Jul 01 21:50:32 EDT 1999 | Big K
I am currently looking into ways to decrease SMT changeover times. I work in a high mix-low volume factory. We use Fuji CP's and IP's for SMT production. I would appreciate hearing from anybody that has some proven methods for reducing setup/changeov
Electronics Forum | Thu Mar 29 10:29:13 EDT 2007 | Scotceltic
A feeder verification tool like Bartector will stop any need for time wasted manually verifying the correct part to the correct feeder. Also, there are plenty of pieces of SMT placement equipment out there that offer offline feeder pallet tables that
.png)
.jpg)
