Electronics Forum | Wed Mar 22 14:46:54 EDT 2017 | solderingpro
Laser Soldering by nature is a very dialed in process. - Requiring specially formulated flux and solder paste applications that will perform while absorbing a massive amount of energy. What I believe "Gary" is attempting to say is: Laser Soldering c
Electronics Forum | Wed Apr 16 14:40:17 EDT 2008 | jdengler
Peter, We have 2 Fuji lines. We run from 5 to 5000 piece lots. When we are running near capacity and have a lot of change-overs scheduled we have special operators that will load parts onto feeders and organize the feeders like they will be on the
Electronics Forum | Wed Sep 08 23:36:12 EDT 1999 | Jason Tomlinson
| | | Dear all, | | | | | | I don't know if I'm asking at the right place here, since you all seem to be more focused on process problems then programming problems (or perhaps programming isn't a problem for you). | | | | | | I'm using FUJI CP642's
Electronics Forum | Thu Jun 21 22:04:18 EDT 2001 | davef
This is my attempt at beating the "Fuzzburg 7" translator used on the SMTnet Forum that mashes everything it sees. Below the next paragraph are three paragraphs,each with a common numering sequence, where each paragraph represents the columns of a t
Electronics Forum | Mon Jun 16 17:13:24 EDT 2003 | fmonette
John, Maybe you know this already but I just wanted to highlight a few facts about dry cabinets. My experience is that many engineers are not well aware of the industry guidelines and sometimes will buy a dry cabinet without understanding the key f
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Sat Jul 03 13:49:36 EDT 1999 | JohnW
50% reduction in time. One draw back, the availability of feeders... You need 280 feeders max to change over a max capacity of 140 feeder machine (or a variance of a product mix vs. part numbers); then there's 8mm, 12mm, 16mm, sticks feeders that c
Electronics Forum | Tue May 01 13:25:20 EDT 2001 | kaoni
Thank you Wolfgang, My time table is the amount of time it takes to get it right. I hope to have product by next December if possible. Yes, I am starting from ground zero. I need to go 201 because of the size limitations as to what I need to fit in
Electronics Forum | Mon Jan 04 11:32:59 EST 1999 | Chrys
| Anyone have any experience with ECD's Waverider/MOLE profiling equipment? If so, were they positive experiences? | I use ECD's mole for profiling in the wave and a KIC for profiling in reflow. I like the KIC a whole lot better for a couple of re
Electronics Forum | Sat Jul 03 18:14:03 EDT 1999 | Earl Moon
50% reduction in time. One draw back, the availability of feeders... You need 280 feeders max to change over a max capacity of 140 feeder machine (or a variance of a product mix vs. part numbers); then there's 8mm, 12mm, 16mm, sticks feeders that c
.png)
