Used SMT Equipment | THT Equipment
Versatec - formerly Contact Systems - CS-400E-R Cut and Clinch with Carousel Model: CS-400E-R Vintage: 05/2013 Voltage: 115VAC Touch Screen Monitor Semi-automatic Component Locator. 30° Table Angle Onboard PC Controller Completely Programmabl
Electronics Forum | Wed Oct 01 15:24:55 EDT 2014 | horchak
are you trying to lengthen or shorten the lead length? Lengthening the amount of lead being cut off and going into the scrap tube will shorten the lead length. Lead length is pretty much determined by the down stop setting on the insertion head, the
Electronics Forum | Wed May 13 17:46:09 EDT 2009 | cusackmusic
Does anybody have any recommended Clinch/Length values for: 1/4W Resistor 1N4007 Diodes 3W Resitors (A bit bigger than 1N4007 leads). Thanks, Jon
Electronics Forum | Mon Apr 04 08:48:33 EDT 2005 | jimih280
that depends on clinch direction, length, and angle. .200" hole center to center is usually safe for all automatic insertion equipment.
Electronics Forum | Fri May 15 22:06:10 EDT 2009 | jrr3434
I use a clinch of 5 and a length of 3 for 1/4w and thicker leg diodes probably a 7 and 5. You really just have to play with the machine it figure out what works best for your application.
Electronics Forum | Tue Feb 23 12:49:10 EST 2010 | gregp
Dilbert is correct. The CS-400E machine is the machine of choice. The component insertions are light guided, the components are automatically presented to the operator and the leads are automatically cut and clinched at programmable lead length and
Electronics Forum | Fri May 11 07:38:14 EDT 2007 | tombr
It is possible to vary the length of lead during auto insert. However, it requires software and mechanical adjustments. Universal equipment allows small changes via software program for lead length. To change angle of clinch involves a mechanical a
