http://www.flason-smt.com/product/YAMAHA-YV100XG-Pick-and-Place-Machine.html YAMAHA YV100XG Pick and Place Machine Yamaha YV100XG pick and place machine Mounting Speed:16200CPH Total weight 1600KG Dimensions 1650*1408*1900 Product description
http://www.flason-smt.com/product/YAMAHA-YV100XG-chip-mounter.html YAMAHA YV100XG chip mounter Yamaha YV100XG Chip Mounter Mounting Speed:16200CPH Total weight 1600KG Dimensions 1650*1408*1900 Product description: YAMAHA YV100XG chip mounter
New Equipment | Industrial Automation
Sales Manager: Sandy Lin Email: unity@mvme.cn Skype:onlywnn_1 Mobile(Whatsapp): (+86)-18020776786 Yuehang: Shipping Term : TNT,DHL,FEDEX,ETC Payment Term : T/T Warranty: 12 month yuehang supply: New+original+factory sealed+high quality
New Equipment | Industrial Automation
Sales Manager: Sandy Lin Email: unity@mvme.cn Skype:onlywnn_1 Mobile(Whatsapp): (+86)-18020776786 Yuehang: Shipping Term : TNT,DHL,FEDEX,ETC Payment Term : T/T Warranty: 12 month yuehang supply: New+original+factory sealed+high quality
Electronics Forum | Thu Oct 30 21:06:20 EDT 2008 | ashley
Hello mickd, For Fuji practice, the primary tooling hole preferably be 5mm from the edge of the PCB (lower right hand corner). This is the reference X0, Y0 co-ordinates in the Fuji program where placing co-ordinates going LEFT will be -ve value & go
Electronics Forum | Tue Jun 14 07:33:58 EDT 2005 | bobpan
If the placement is off the same amount everytime...(which I suspect it will be)...just adjust your placement co-ordinate for the part and be done with it.
Electronics Forum | Tue Aug 03 03:13:17 EDT 2004 | V.R.Kini
Bent nozzle can result in vaccum leakage resulting in parts falling during part pick up. Correct this. However, if your machine has laser/vision alignment, you should not be having a problem since these come in to picture after pick up. If you have a
Electronics Forum | Thu Nov 03 09:43:55 EST 2005 | lupo
Check flux penetration and type of flux. How much is solid contents. The solder filling is better under Nitrogen. Check the time (speed) of the nozzle whether is correct. Usually For SAC305 the temperature of bath is 320C/degrees, but only for sel
Electronics Forum | Tue Jan 09 08:26:51 EST 2007 | stepheniii
If your boards are not totally rectangular part of the board can stick out past the stopper. If the fiducial is there then you can't use it. Also make sure you are not using panel fiducial co-ordinates and then expanding those out with panelization
Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone