Electronics Forum | Mon Apr 02 10:11:58 EDT 2012 | jdumont
Wondering how you guys do this. Scenario: You have to rework a part (small IC or resistor) on a board that has already been conformal coated with acrylic. What do you do with the post soldering residues before you cover it up with fresh coating?
Electronics Forum | Wed Apr 14 17:13:08 EDT 1999 | Stephen Oltmann
| I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches heated length and 18 or more inch wide belt. The material we are consid
Electronics Forum | Wed Apr 14 17:14:49 EDT 1999 | Stephen Oltmann
Check with BTU. They have dryers in the length you need. Good luck! | | I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches
Electronics Forum | Sat Apr 17 11:56:04 EDT 1999 | Graham Naisbitt
Mike First, you MUST make sure the oven used is extracted. The coating will contain TDI. This is not nice. You would be better considering a silicone solventless. Try contacting HumiSeal. They had a material on the TAC line at Nepcon West that lo
Electronics Forum | Wed Apr 14 20:39:02 EDT 1999 | Dave F
| I need to cure conformal coat on a 19" x 15" board. The material needs 7 - 10 minutes at 100deg C, but I have limited floorspace so I'm looking for an oven with about 36 inches heated length and 18 or more inch wide belt. The material we are consid
Electronics Forum | Tue Dec 23 11:55:37 EST 2003 | Marc Simmel
Details, details: 1) The metal shell is part of the component body. The base metal is austenitic stainless steel (304) that has been plated with 90/10 tin-lead over nickel (semi-bright). 2) The entire part (leads and shell) is elevated by the mass o
Electronics Forum | Tue Nov 10 12:43:13 EST 1998 | Dave f
| What are you people using to store component reels and tubes in? I am looking for a cabinet with slots or something to store reels and tubes. We keep our components on the production floor near the machines. The cabinets we are using now are ver
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
