Electronics Forum | Sat Feb 02 08:55:55 EST 2002 | davef
I'd don't believe that the reels need to be ESD protective material. The carrier and cover tape have resistivity and materials specifications. Start with EIA-481. In past threads on SMTnet, we have discussed problems in picking components that wer
Electronics Forum | Wed Jun 19 01:11:20 EDT 2019 | relaycz
The few timeds this happened to me, it was taken care of by cleaning the feeder thoroughly. Be sure to check moving part for damage.
Electronics Forum | Tue Jun 25 11:26:11 EDT 2002 | pdt203
Sometimes when a customer has sent parts on reel without any leader, we will take out the first 5-8 parts and then tie off the cover tape with some leftover tape from the last run. We keep those parts we removed and then place them back in the feede
Electronics Forum | Sun Jun 23 02:16:47 EDT 2019 | emanuel
Some manufacturers put very strong glue, the wider the part is so increases the glue strength. May sound funny but the only thing that worked was attaching a fishing weight to the tape, need to play a little until you find the correct size. The only
Electronics Forum | Tue Jun 18 23:29:02 EDT 2019 | SMTA-David
Hi, I have an older Samsung pick and place (CP-40LV model). During last few runs I have experienced several feeders with the clear plastic tape cover not peeling back to expose the next part. I manually pull back the tape and it runs for a while and
Electronics Forum | Thu Mar 14 17:35:39 EDT 2013 | dontfeedphils
Have you looked at the cover tape wheel on these different feeders and made sure that they are turning correctly when the feeder is advanced? There's not too many things that could be wrong, either the wheel isn't turning properly and keeping the co
Electronics Forum | Wed Apr 03 10:25:04 EDT 2013 | gregp
We all seem to have forgotten about cover tape peel force testers. GPD makes them as do others I suppose. I would ask the tape and reel house if they have a tester. If they don't I would consider using someone else. Otherwise as another poster s
Electronics Forum | Mon Jan 31 15:02:52 EST 2005 | gs
First of all ask your Suplliers to provide you SMD in Tape & reel, second point, you can ask Service for Tape & Reel or in case components are not so many, you could asses ef convenient to buy a sinple maual Tape & Ree machine and do it inside your f
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
Electronics Forum | Thu Mar 21 22:27:13 EDT 2013 | padawanlinuxero
Hi ! I have the same problem with some rolls of tape, we did check the feeder magazines in our mydata machines but turns out the problem is with the plastic cover sometime it comes with just too much adhesive that the feeder magazine cant peel the p
.png)
