Electronics Forum | Wed Apr 19 06:56:54 EDT 2006 | QTEK Manufacturing Ltd. www.qtek.com
QTEK Manufacturing Ltd. provide a solution to the above problem, QTEK Cover Tape Extender adds an extra 380mm to cover the tape of component reels. It saves components being wasted or discard when strating a new tape through a feeder, and enables the
Electronics Forum | Thu Mar 30 13:15:31 EST 2006 | jdengler
This will depend on the feeder design. Some feeders cause a loss of several components when removing a reel from a feeder. If yours do not, the operator should be able to leave enough tape and mylar cover tape for this reel to be put back onto a fe
Electronics Forum | Fri Mar 31 16:06:58 EST 2006 | GS
I think this can be of help when dialing with setting up feeders for product prototyping, where often we have to dial with a short quantity of components (often pieces of carrier tape w/o tape and cover leader) just enough to run (if lucky) those few
Electronics Forum | Thu Mar 30 13:15:17 EST 2006 | gregp
Maybe the issue is how the feeders are being unloaded. The operators should leave enough covertape to reload the reel onto a feeder without component waste. If the issue is some parts are exposed in the feeder then you will most likely loose those p
Electronics Forum | Fri Aug 04 10:08:18 EDT 2000 | John Thorup
Zactly...what type and size of component. Pressure sensitive or heat seal cover tape? Manufacturer or service house taped? One or all manufacturers/distributors. Are the components in the right size tape? Reasonably recent production? Are they rea
Electronics Forum | Mon Aug 07 04:25:00 EDT 2000 | dougie
Hi Guys, Thanks for the response. To answer your questions... The compoments we are placing and experiencing trouble with are generally 1206 components. It isn't just one manufacturer either. The one part though we have most problems with though is
Electronics Forum | Mon Jul 25 09:11:25 EDT 2016 | spoiltforchoice
There 2 main rival standards for orientation in tape and because you can't really trust manufacturers to stick to one or the other or something else entirely it is always wise to check the datasheet. Typically an SOIC will have pin 1 the same end as
Electronics Forum | Wed Dec 13 12:08:57 EST 2000 | Stefan Witte
Apparently the adhesive tape peels off from the joint, which could have some reasons. 1. There should be an overlap of the cover tape, as Cal mentioned. The new cover tape laying over the old by approx. 2mm. I also peel the cover tape a bit off, whi
Electronics Forum | Tue Feb 20 15:39:31 EST 2001 | fmonette
To my knowledge, the 40C was established as the maximum "safe temperature" for all tape and reel packaging. The actual specs may vary somewhat for different types of reel, pocket-tape, cover-tape but you must be concerned with the cover tape adhesive
Electronics Forum | Thu Mar 14 17:35:39 EDT 2013 | dontfeedphils
Have you looked at the cover tape wheel on these different feeders and made sure that they are turning correctly when the feeder is advanced? There's not too many things that could be wrong, either the wheel isn't turning properly and keeping the co
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.jpg)
