Electronics Forum | Wed Apr 03 10:25:04 EDT 2013 | gregp
We all seem to have forgotten about cover tape peel force testers. GPD makes them as do others I suppose. I would ask the tape and reel house if they have a tester. If they don't I would consider using someone else. Otherwise as another poster s
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
Electronics Forum | Thu Mar 21 22:27:13 EDT 2013 | padawanlinuxero
Hi ! I have the same problem with some rolls of tape, we did check the feeder magazines in our mydata machines but turns out the problem is with the plastic cover sometime it comes with just too much adhesive that the feeder magazine cant peel the p
Electronics Forum | Wed Mar 20 12:59:10 EDT 2013 | kmots15
We had this issue with a few parts on our universal 8mm feeders. The set up was correct all mechanisms were working, even tried a new feeder. The spring in between the take up wheel and pick point just wasnt cutting it since the adheasion was too m
Electronics Forum | Wed Jun 19 01:11:20 EDT 2019 | relaycz
The few timeds this happened to me, it was taken care of by cleaning the feeder thoroughly. Be sure to check moving part for damage.
Electronics Forum | Sun Jun 23 02:16:47 EDT 2019 | emanuel
Some manufacturers put very strong glue, the wider the part is so increases the glue strength. May sound funny but the only thing that worked was attaching a fishing weight to the tape, need to play a little until you find the correct size. The only
Electronics Forum | Tue Jun 18 23:29:02 EDT 2019 | SMTA-David
Hi, I have an older Samsung pick and place (CP-40LV model). During last few runs I have experienced several feeders with the clear plastic tape cover not peeling back to expose the next part. I manually pull back the tape and it runs for a while and
Electronics Forum | Wed May 22 15:56:43 EDT 2002 | stefwitt
The play of the tape is quite significant as I mentioned in an earlier thread. Tape width can vary between 8.1 +/- 0.2mm. Demos on 0201's are most likely done with 8.1 +/- 0.05mm tape. I guess you are referring to the cover tape pull, which can dispo
Electronics Forum | Mon Jun 29 15:25:09 EDT 2020 | jmelson
Spoilt, OK, a good point in your message, what good is a machine with 15 mm component height capability if there are no feeders that support that tall a component! I hadn't thought about that aspect! (My Philips CSM84 is limited to 6.5 mm, and I r
Electronics Forum | Wed Aug 07 01:44:52 EDT 2019 | orbitcoms
I have several reels of components I purchased from Chinese source. During pick and place, the tapes keep breaking (they tear diagonally along the reel). I notice the tape is very tight if I try to pull through manually. I tried several over 12mm fe
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411