Electronics Forum | Mon Aug 25 07:30:09 EDT 2008 | jdengler
CVD Equipment Corporation bought Conceptronics and still supports the HVA series. See http://www.conceptronics.com Jerry
Electronics Forum | Mon Jan 07 10:56:40 EST 2002 | bcaler
Who did you buy this oven from? What is the model number? I bought a used Conceptronic oven last year...It ran great when I saw the demo. But, when is arrived at our factory we found someone pulled out some relays and it wouldn't heat. Hope you h
Electronics Forum | Thu Feb 09 09:45:50 EST 2006 | PWH
I'm not familiar with the HVN70 programming but our conceptronic oven reacts well to adjusting the cooling fan speed at the end of the oven. However, TAL will likely be affected substantially by changing fan speed.
Electronics Forum | Wed Aug 27 08:53:18 EDT 2008 | mgrimes
Contact Jim Brewington at (603) 516-7335 or Irene Bateman at (631) 981-7081 Ext. 209. service(at)conceptronic.com is a good email address for them as well.
Electronics Forum | Wed Jan 16 12:57:29 EST 2002 | Kevin Neal
Check all of the interlocks. The heaters and conveyor will not power up unless all of the interlocks are closed.
Electronics Forum | Thu Jan 25 12:50:45 EST 2007 | stepheniii
What about the relay that controls the heater? I've seen that problem on conceptronics ovens. The relay would latch on and never turn off.
Electronics Forum | Thu Aug 28 07:35:19 EDT 2008 | chrispy1963
Thank you to you all. Ive emailed Jim and he replied to me with part numbers, prices and phone numbers and email addresses. Have a great holiday weekend one and all!!!
Electronics Forum | Tue May 16 14:49:57 EDT 2006 | james
I know this is an old one, but we still have problems on our heller oven with parts blowing off their pads. Our other oven does not do this and it is a conceptronics oven. We do not currently have the adjustable fan speed on our heller oven. My q
Electronics Forum | Thu Feb 09 09:36:55 EST 2006 | aj
All, I would like to find out if it is possible to adjust the cooling rate on a Conceptronic Reflow Oven Model HVN70. We do not use Nitrogen and the Cooloing system is Genesis GCM-1. From profiling it seems to be cooling too quickly. Any replies a
Electronics Forum | Tue Sep 16 10:25:34 EDT 2003 | James
We do have a convection oven and no one has messed with it. I am the only one who can change anything. I have it set at Medium right now on a conceptronics oven. Could this be too high? We have not had problems in the past with parts moving off o
