Electronics Forum | Mon Sep 10 08:40:21 EDT 2012 | donkudner
After selecting a few ovens based on the mfr's specifications, I plan to send them a thermal "slug" to run in their ovens (a 1/4" thick, high temp fiberglass slab with imbedded thermocouples). Since we are replacing ovens with fixed speed blowers wit
Electronics Forum | Sun Sep 13 18:45:24 EDT 2009 | halleyjoan
Is there any possible way to repair the blower of vitronics reflow oven if it stuckup? How to replace its blower? Or i should be replaced as 1 assembly (cell motor and blower assembly).
Electronics Forum | Tue Mar 01 23:55:41 EST 2011 | cmguan79
Hi all, Need help troubleshooting for I've just bought a 1997 second-hand oven HVC102. Unfortunately, after loading profile & press run mode we found all TC READING IS ZERO & CONVEYOR READING FEEDBACK IS ZERO SHOWN ON MONITOR SCREEN ,& I LOSS PA
Electronics Forum | Thu Feb 26 10:38:00 EST 2015 | swag
We don't have parts around anymore but I can offer a tip that might help. Our conceptronic is gone but the major issue we had with it was bearings going out on blowers. We rebuilt them in-house. Found a high temp. bearing through a bearing supplie
Electronics Forum | Wed Mar 01 11:39:15 EST 2017 | ivammendes
Thank you guys for the answers. I have solved a part of the problem. I replaced the caps that Rob mentioned and some blowers start working. I still have problems with 2 heats. One of them the blower is not working even changing the cap. The other one
Electronics Forum | Thu Sep 16 12:06:29 EDT 1999 | Scott S. Snider
| | | Hi, | | | | | | Can someone pls suggest to me the best reflow temperature setting | | | for a force air convection oven. The details is as follow. | | | 1) Heller 1700s | | | 2) 12 zone---6 top and 6 bot | | | 3) Solder paste --- Qualitek 691
Electronics Forum | Fri Jun 03 14:55:15 EDT 2005 | Bman
Both our Quad ZCR and our Conceptronic HVN-102 ovens have had blowers out with no alarms raised. We knew there were problems based on how boards were soldering, but don't count on your oven to tell you if anything is wrong with it. We verify once a
Electronics Forum | Mon Oct 17 14:00:14 EDT 2005 | ricardof
for sure it's an excelent topic, in Mexico we've used almost any brand in the market (Research, Heller, Electrovert, Rhem, Vitronics, Conceptronics, BTU) and after all those names, we could see that Vitronics is a good opton, good service, not too mu
Electronics Forum | Mon Mar 20 10:25:30 EDT 2017 | cyber_wolf
@ Westshoredesign: Go take the top covers off your XPM's. Tell me if you see flux residue on the blower motors and the surrounding area. If you see this, grab ahold of the blower motor and rock it back and fourth. It is moves, the seals are melted o
Electronics Forum | Thu May 28 12:05:11 EDT 2009 | wrongway
We have A heller 1809 2005 model have replaced the chain drive motor twice have replaced 2 top blowers and one bottom blower as far as reflowing the solder performance has been great. the tech support has been great as well. we run 3 shifts 5 days