Electronics Forum | Mon Aug 06 14:24:12 EDT 2018 | dleeper
I had a similar problem once on an acculfex. The root cause was a short on the one the wire harnesses connected to the print head. If I recall, most of the relays in an accuflex are actuated by the 24 volt bus, so if you have a short anywhere in tha
Electronics Forum | Sat Jul 19 12:07:46 EDT 2008 | operator
I have alot of experience creating assembly drawings for SMT and THT products. However, we are now doing very large ,complicated box builds that have many terminal blocks, point to point and cable harnesses. It is my job to create these assembly doc
Electronics Forum | Sat Sep 26 02:09:39 EDT 2015 | aemery
Proc My field service back ground included Electrovert so I know reflow electrical quite well. I've worked on Heller, Conceptronic and Vitronics over the last few years and really there isn't a huge difference if you can read a schematic. I checked
Electronics Forum | Wed Apr 24 14:14:57 EDT 2002 | stefwitt
If nobody else can help you and you are not afraid to add a bit of hardware, I would like to give it a try. If pistons are air activated there should be a solenoid for each piston. Locate the I/O signals, wire in a double through switch and apply 24
Electronics Forum | Fri Jun 29 18:36:54 EDT 2018 | crstarr
Hello - I just purchased a used Conceptronic (Philips) HVC-70 Reflow Oven and am in need of the complete manuals (wiring; programming; maintenance; etc. -OR- Someone who currently uses this oven and/or knows everything about it. I was told this o
Electronics Forum | Thu Dec 22 11:18:59 EST 2022 | emanuel
I am interested to know if you solved this problem. We are experiencing something similar. The table is the first node in the CAN chain. As I see the structure, the CAN starts from the Nextmove ES card, goes first to the table driver and continues to
Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Mon Jun 26 03:56:44 EDT 2006 | slaine
hi I had a hunt round this morning and found all the schematic drawings for the vip70. Have you got a copy of them? where abouts in the uk are you im in Cumbria. drawing 5061617 appears to show some different wiring configerations, but im not sure if
Electronics Forum | Sat Oct 10 02:59:53 EDT 2015 | aemery
AVCOM, I have worked on a few of the Conceptronic ovens recently for one of my clients. They had a similar issue, all the heaters dropping out with a high temp circuit error which kicks out CON1 (Heater power). If you're saying what I think your sa
Electronics Forum | Mon Sep 28 09:31:43 EDT 2015 | proceng1
Proc > > My field service back ground included > Electrovert so I know reflow electrical quite > well. I've worked on Heller, Conceptronic and > Vitronics over the last few years and really > there isn't a huge difference if you can read a > sc
