Electronics Forum | Fri Apr 24 13:50:44 EDT 2015 | duchoang
Try to check the SSR (Solid State Relay) in the back panel. You may need to replace one or some of them. Good luck.
Electronics Forum | Mon Jun 01 09:41:00 EDT 2015 | tnisbet
It could be the control board that mounts onto the backplane board of the pc, if you have any further questions you can contact george@goppm.com
Electronics Forum | Mon Oct 05 10:08:54 EDT 2015 | swiese242
I have a HVC 102 reflow oven that will randomly shut down for over/under heat. On the 601 overheat protection zone 4 will read over 500c. Has anyone had this problem?
Electronics Forum | Mon Oct 12 07:12:45 EDT 2015 | swiese242
Thanks! it was one of the T/C not over the hole. After looking all them over I had 3 not over the hole. Oven is running fine now.
Electronics Forum | Wed Dec 16 07:09:36 EST 2015 | jdengler
I have seen bad transistors on the expansion boards cause no display of temperatures from the thermocouples. Jerry
Electronics Forum | Mon Oct 16 07:38:17 EDT 2017 | cyber_wolf
Here, I did the footwork. https://en.wikipedia.org/wiki/Reflow_soldering http://www.conceptronic.com/products/solder-reflow-technology-handbook/section3.pdf
Electronics Forum | Mon Feb 28 19:36:39 EST 2000 | Tony
I work for a contract manufacture of PCB's, we are also in the BGA rework business. We see all kinds of different size boards, as well as different types of BGA's and micro BGA's. We selected the Conceptronics Freedom 2000 over the Air Vac and SRT. T
Electronics Forum | Mon Feb 28 19:36:39 EST 2000 | Tony
I work for a contract manufacture of PCB's, we are also in the BGA rework business. We see all kinds of different size boards, as well as different types of BGA's and micro BGA's. We selected the Conceptronics Freedom 2000 over the Air Vac and SRT. T
Electronics Forum | Tue Oct 12 15:20:44 EDT 1999 | Jim Schultz
I need your help! We have been doing double sided surface mount for 4 years now. Up until 6 months ago I have not had a tombstoning problem. Since then I have a fairly high incidence rate of tombstones on the 0603 size resistors (no other parts).
Electronics Forum | Tue May 11 12:02:03 EDT 1999 | Tony
| We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | All other tips are also welcome. | | Thanks | Philip, I have been doing BGA rework for
