Electronics Forum | Thu Jan 08 16:21:05 EST 2004 | Bill
James: The ovens can be calibrated to help get this a little closer. In the computer box are 3 cards (alike) attached to the motherboard. They are called IPS-7 cards. On these cards are 2 potentiometers to calibrate the T/Cs for the heat zones. There
Electronics Forum | Wed Jan 07 13:17:56 EST 2004 | James
We currently have 2 HVA 102 conceptronic reflow ovens. I ran 2 profiles on the 2 seperate machines. One of the oven ran 7 degrees lower than the other oven. I checked all the fans and they seem to running fine. I get no warning on the monitors.
Electronics Forum | Mon Oct 12 07:12:45 EDT 2015 | swiese242
Thanks! it was one of the T/C not over the hole. After looking all them over I had 3 not over the hole. Oven is running fine now.
Electronics Forum | Wed Dec 16 07:09:36 EST 2015 | jdengler
I have seen bad transistors on the expansion boards cause no display of temperatures from the thermocouples. Jerry
Electronics Forum | Thu Mar 10 12:46:17 EST 2005 | jimk
Does anyone have experience in N2 supply source for reflow oven (1000scfh) other than N2 generator? Tanks, liquid, etc. We are in the developement stages of lead free processing and would like a quick, short term solution for providing N2 to a Concep
Electronics Forum | Fri Jun 03 14:55:15 EDT 2005 | Bman
Both our Quad ZCR and our Conceptronic HVN-102 ovens have had blowers out with no alarms raised. We knew there were problems based on how boards were soldering, but don't count on your oven to tell you if anything is wrong with it. We verify once a
Electronics Forum | Wed Jun 21 16:04:07 EDT 2006 | bman
"Another question, is the facility with 200A @ 208V able to operate this assembly line properly?" That could be a problem, big ovens pull a lot of juice. Our 7 zone Conceptronic HVN-102 runs on 480 Volts and is on a 160 amp breaker, for example. Y
Electronics Forum | Mon Aug 25 01:19:51 EDT 2008 | chrispy1963
We've got an older Conceptronics HVA102, 7 Zone, relow oven running software with the following info: (1) Machine Software Ver. Date: 9-1-94-Windows Rev 2.50c. (2) EPROM rev for the machine is: 386 AT WINDOWS (3) 486DX2 PC running Windows 3.1 as
Electronics Forum | Wed Jun 13 16:20:33 EDT 2001 | Gregory Stanton
Does anyone know of a quick method for developing reflow profiles for a Conceptronics HVA 102 reflow oven? Our plant is exceptionally busy and it's difficult to get access to the machine. I've been told by a few folks the oven has enough zones (7)
Electronics Forum | Wed May 12 12:22:38 EDT 2004 | solderpro
I agree with the guy about cars, boats, ect... ok, I like as some have said without a doubt, DEK top of the line.... pick and place, love siemens but software is not user friendly, myself, JUKI all the way, great equipment, great software, that mean
