Electronics Forum | Wed Jan 31 10:56:23 EST 2018 | dontfeedphils
I'm working on bringing up a new conformal coat process/workcenter and have a few questions I'm hoping someone might have experience with. Right now we're manually spraying both coating materials (1B31 and 1A33 from Humiseal) using HVLP guns. I run
Electronics Forum | Fri Apr 07 17:17:55 EDT 2000 | Dave F
Ashok: You should select and use low residue tapes. But ya know, ya go out and research a great tape and if yer not careful, the buyer will second source ya and (surprise) ya got residues again. We have found that Lemme say this about Katon tape
Electronics Forum | Fri Mar 20 10:31:19 EST 1998 | Mick Jones
| I will be starting a conformal coating process soon, I am looking for any pointers on | 1) Best method for masking components, tape mask, liqued mask | 2) Which is best Spray or Dip? | 3) Compatiblity with no clean solder paste (flux residue) | I h
Electronics Forum | Tue Apr 11 20:23:19 EDT 2000 | Dave F
Ashok: You're still goin' down that ol' ESD road aren't ya bud? Why do you need the boards to be dry? Conformal coating? Hey wait a minute, are you one of those no-clean people? Er zis related to the Kapton tape res fandango? Anywho, be careful
Electronics Forum | Tue Jun 17 12:57:26 EDT 2008 | sleech
You are correct. For the 70 deg. C drying temperature to be effective, the relative humidity must be as near to zero as possible. A pulling a vacuum on the chamber is an inexprensive and reliable way to accomplish this. Contrary to some claims, our e
Electronics Forum | Fri Nov 05 11:30:53 EDT 2010 | deanm
We have a Quad QSV-1 pick and place machine that has performed fine for us with the exception of cylindrical glass (MELF) type diodes. The machine often fails to pick these out of the tape to the point where it is easier to hand place them. As far
Electronics Forum | Sat Apr 21 08:26:57 EDT 2007 | Cmiller
Has anyone experienced a problem with conformal coating adhesion to IS-410 boards? We are having problems with one suppliers boards. IS-410 boards from other suppliers are fine and all FR-4 boards that I have looked at are fine. We are using Conap
Electronics Forum | Tue Nov 01 10:06:00 EDT 2011 | davef
Humiseal says: Typically, there are three main approaches to avoid coating wicking into press-fit connectors (and other keep out areas). Wicking is a phenomenon caused by a combination of low viscosity of conformal coating material and strong capilla
Electronics Forum | Thu Dec 22 10:51:12 EST 2005 | killer1994
Yes, I have been using it for 4 years now. We have the 4 axis, 3 head, 2 lines. Inspection station and ir oven. I have to say you will NOT get better support anywhere in this industry than from PVA. Their crew is top notch, always going above and bey
Electronics Forum | Wed Feb 10 08:10:26 EST 2010 | davef
Here is a posting by P Kinner at Humiseal ... Typically, there are three main approaches to avoid coating wicking into press-fit connectors (and other keep out areas). Wicking is a phenomenon caused by a combination of low viscosity of conformal coa