Electronics Forum | Thu Feb 12 13:01:12 EST 2004 | patthemack
Thanks for your response. This is a DeHaart MPC-29. It has manual vision, no conveyor. When I bought it, only one camera was working. I fixed that, but while I was jacking with that, the electronic pressure regulator (spcjr) burned up without warning
Electronics Forum | Thu May 12 04:37:30 EDT 2005 | Rob
1) Only if it's a real enhancement, and not to fix a fault in your design. 2) No, it just has to be instinctive & accurate. 3) Barcode is fine by me, but others swear by data matrix 4) Better than 1 in 10,000 - which could be once every 5 boards.
Electronics Forum | Mon Jan 30 16:30:55 EST 2006 | GS
Hi James, it could be the problem is due to residual of cleaner media entrapped under low gap of QFP 208 and 0,5 mm lead pitch. I remember in the past we had random problems of failure at test after board wash off process (DI Water wash). We met
Electronics Forum | Thu Mar 01 21:20:47 EST 2007 | J.R.
Let's talk pin holes and blow holes. I've been here since the transistion of leaded to lead-free process started for our company and we purchased a wave machine just to keep up with our lead-free orders. we put out 500-1000 boards a day both leaded a
Electronics Forum | Fri Oct 02 01:21:08 EDT 1998 | Mike Cox
Kyung Sam, | | Justin is correct, there is definately either a board design problem or the PCB maker issue. Obviously there are many mixed technology boards built in the world so I would lean towards a design issue as the root cause. Should you or
Electronics Forum | Wed Jul 14 11:36:56 EDT 1999 | Jimmy Strain
| | | Hi All, | | | Does any one experienced the solder on gold finger after | | | reflow. Its about 5 to 8 mils diameter . | | | We'd clean the entire screen printer, mounter & reflow as well, | | | but doesn't help much. | | | | | | | | Mr Kong..
Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
