Electronics Forum | Mon Apr 02 20:47:22 EDT 2001 | davef
Cuppla questions for ya ... Where are the shorts [above the mask or between the mask and the laminate]? On the board, what material is between the copper traces and the mask? What type of solder mask(s) used by your suppliers? What are they using
Electronics Forum | Mon Mar 07 20:27:07 EST 2005 | KEN
Oh silver and its...improved solderability over tin / copper. BS if you ask me. Look to your flux and thermal profile for wetting spread. Ask yourself just how much "wetting spread" do you need to fill a barrel? I have the same 100% barrel fill
Electronics Forum | Sat Nov 08 09:10:16 EST 2008 | davef
SN100 was designed for selective soldering and producing low levels of voiding. But thin barrel plating is a common cause of voids in wave and selective soldered connections, as you say. As a result, you checked the plating thickness and it was accep
Electronics Forum | Tue Mar 28 08:29:04 EST 2006 | davef
Pad design - Standard IPC 20 pitch QFP Thermal pad design - Layout the thermal pad 0mm to 0.15mm larger per side (0mm to 0.30mm larger overall) than the exposed die pad on the package. �Larger than�, as opposed to the same size, is preferred. Obvio
Electronics Forum | Thu Jun 03 20:09:56 EDT 1999 | C.K.
I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole." These def
Electronics Forum | Fri Jun 04 11:30:40 EDT 1999 | Earl Moon
| I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole." The
Electronics Forum | Fri Jun 04 11:31:27 EDT 1999 | Tony
| I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole." The
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Fri Feb 28 08:57:34 EST 2003 | davef
We used to bake [100*C for 6 hours] all of our boards, but no longer bake at all. Before going off, your bake recipe is probaly OK. If anything, it's probably too short. Consider measuring the weight of wet boards, baking for a time, measure, bake
Electronics Forum | Fri Jun 04 03:03:52 EDT 1999 | Scott B
| I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole." The
