Electronics Forum | Sat Jan 23 13:29:40 EST 1999 | Earl Moon
| Hi Everyone, | We plan to build, for reliability/experimental/research purpose some CSPs (namely Tessera microBGA 46-I/O 0/75mm pitch and TI 64 I/O 0/8 mm pitch). the various factors that we plan to evaluate are the reliability and assembly concern
Electronics Forum | Thu Jun 10 12:10:41 EDT 1999 | Earl Moon
| | | I am starting a new project which involve 3 oz copper layer with 20 mil components on the top of the board and 0.040" thick copper with D2Pak on the bottom of the board. | | | There is anybody has experience on metal-based PCB reflow process?
Electronics Forum | Wed Mar 10 17:03:52 EST 1999 | Morziana Hasan
NASA CommQuest Photopolymerized Conducting Polymers Directions: 1.Please read the information provided on this technology. You may follow the links to additional information resources below. 2.After evaluating the technology, please answer the
Electronics Forum | Thu Jan 25 04:55:08 EST 2007 | greg york
Strange as we have had huge problems with Silver in Many different Assembly houses. Mainly with Nitric Acid based Silvers causing blow holes, non wetting and even the Nitric etching away the tracks on fine boards. It has been one of the main problem
Electronics Forum | Thu Jun 12 03:37:05 EDT 2008 | benefon
It is also possible to etch the barcodes directly on the PCB by using a laser. The solder resist mask is easily burned by laser and if there is copper underneath the contrast is quite good. The contrast is satisfactory even if there is no metal under
Electronics Forum | Sun Jun 06 13:03:14 EDT 2010 | whitewing
I'm sure you could buy everything you need to make your own stencils in-house for way less than 200K - lasercut or photochemical etch. If you have someone local with a typesetter of photoplotter , photoetch should be really cheap to set up. I've also
Electronics Forum | Tue Oct 04 20:31:16 EDT 2016 | davef
IPC-7721, Section 6.1, Jumper Wires, Jumper Wire Selection #5 states: "Recommended wire is solid, insulated, plated copper wire, 22 to 32 AWG with a heat resistant insulation. Wire with tin-lead plating may be restricted due to environmental laws."
Electronics Forum | Thu Feb 01 03:02:50 EST 2018 | robl
Hi Rob, > > I did check with the board house, and > the confirmed that there was no Nickel plating, > but that the silver went straight onto the copper > in their immersion silver > process. > > Interestingly I've even tested an > unplated sam
Electronics Forum | Fri Oct 30 01:07:34 EST 1998 | Earl Moon
| I am a recently graduated Process Engineer. I am working for a company developing and manufacturing printed circuit boards. I am looking for a web link, magazine article, book, etc which describes the processes which happen at a board house. More s
Electronics Forum | Thu Aug 13 12:55:46 EDT 1998 | Dave F
| Hi, can you please tell me how to make green coating and through-hole plating of PCB? Thanks! | Xingsheng Xingsheng: Welcome. Bible on PCB fabrication: Printed Circuits Handbook, Clyde Coombs, McGraw-Hill Web resources: http://www.pwbrc.org/ a