Electronics Forum | Tue Aug 01 11:30:11 EDT 2006 | heyitech
We need to sold compnents on the copper board(1.5mm thick)by using lead free solder paste. please give me some suggestion if you have experiences on this issue. thank and regards
Electronics Forum | Wed Apr 06 21:37:35 EDT 2005 | KEN
Are you saying you have solder balls (as in solder paste balls) at the lead tips (or land tip)? This means your thermal profile is not hot enough. why the sudden cahnge? I will bet the lead frame material was copper and is now alloy 42. sounds like
Electronics Forum | Sun Apr 15 18:06:16 EDT 2007 | greg york
You may need slightly longer dwell times and a little more heat in the reflow and wave to ensure proper alloying/wetting. Also consider if you are using a nickel doped and high copper alloy on bare boards in Leaded wave solder bath you will pick up c
Electronics Forum | Thu Jun 08 23:26:28 EDT 2006 | Shawn Vike
We are a small company, reletivly new to doing our own SMT (1 year) and we are having an issue, I think. We manufacture many board with no problems, but we have one that constently defeats us. This particular PCB has ENIG finish, and we have had th
Electronics Forum | Fri May 28 07:37:52 EDT 1999 | Steve Cheung
Yes l know this problem keeps cropping up on the forum but l've missed some of the follow-ups. Our problem is that the lifting only occurs on 3% of production so actually detecting an improvement is difficult. We're actually having to inspect 144 p
Electronics Forum | Fri May 01 08:15:36 EDT 2009 | davef
Scavenging Methods [Improve Solder Scavenging of Large Area-array Sites, SMT, Laurence Harvilchuck, process research engineer, Unovis Solutions, harvilch@unovis-solutions.com] Two common methods exist for scavenging residual solder on the site for s
Electronics Forum | Mon May 18 20:57:06 EDT 1998 | Earl Moon
.025" pitch so the only problem we run into is too much HASL on the adhesive side causing improper glue dispense. | As Earl keeps saying HASL thickness is hard to impossible to control. I think we need to look hard at OSP's again but then you get in
Electronics Forum | Mon May 18 22:54:04 EDT 1998 | Dave F
.025" pitch so the only problem we run into is too much HASL on the adhesive side causing improper glue dispense. | | As Earl keeps saying HASL thickness is hard to impossible to control. I think we need to look hard at OSP's again but then you get
Electronics Forum | Mon May 18 13:30:15 EDT 1998 | Earl Moon
| I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered and solde
Electronics Forum | Thu Dec 08 01:05:34 EST 2005 | Mike_Kennedy
Our new PCB supplier can give us a 20% price reduction if we convert from an ENIG finish to a FLASH gold finish. My uderstanding between the two is as follows: ENIG - Nickel is plated over copper and then immersed in Gold which forms a self limited f
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
