Electronics Forum | Tue Dec 10 10:26:56 EST 2002 | davef
Questions are: * What is the current plating on the connector that is over the "plating of the leads is Nickel (99.9% purity)"? * What are the temperatures and durations at those temperatures that you read on these connector leads? * What solder allo
Electronics Forum | Mon Aug 09 20:47:21 EDT 2004 | KEN
I think OA flux left on the pot would quickly looses its activity and become part of the dross waste stream, and smoke stream for that matter. Also, if your wave is setup properly your selective pallets will scour (push) the top of the lambda wav
Electronics Forum | Fri Dec 12 01:06:02 EST 2003 | kenny
Dear folks; I am currently looking a PCB manufacturer who can fabricate PCB with the following specification:- Board sizes: _20000__ x _20000__ mils Thickness: 125 mils PCB material: FR4 Surface finish: 30 microinches Gold over 200 micro inches Nic
Electronics Forum | Sat Aug 02 08:12:05 EDT 2003 | davef
Q: So, can I concluded that this greenish "fungus" looking staff is not initiated from high hot air temperature setting ? A: Your temperature setting could have increased the growth rate of this crunchy looking stuff, but we wouldn't start there to
Electronics Forum | Tue Apr 20 20:11:58 EDT 2004 | davef
First, how oxidized are these solder balls? Will the take solder using your routine flux / paste? Second, on restoring solderability, the three basic methods you can use to restore solderability on components are: * Highly active fluxes in a retinn
Electronics Forum | Mon May 10 20:46:25 EDT 2004 | davef
The three basic methods you can use to restore solderability on components are: * Highly active fluxes in a retinning operation. * Surface stripping chemistry and then a standard retinning operation. * Electrochemical conversion chemistry and then a
Electronics Forum | Sat Nov 14 08:05:54 EST 1998 | Earl Moon
| | | | I believe that gold fingers on my circuit boards are being | | | | contaminated and need to clean them with some chemical | | | | solution. Any recommendations. | | | | | | | Chuck: What is the type and source of your contamination? Dave
Electronics Forum | Wed May 16 15:40:56 EDT 2012 | davef
Here's some notes from a Bob Willis presentation Assembly of Flexible Circuits with Lead-Free Solder Alloy [Bob Willis leadfreesoldering.com] * Flexible Circuit Construction ** Base Material - 0.05mm Copper 18/18 um ESPANEX from Holders Technologies
Electronics Forum | Fri Aug 30 16:25:21 EDT 2002 | davef
Imm silver holds-up to multiple thermal cycles very well. The things, we guess, are happening to make imm silver tough to solder after heating and sitting are: * Oxidation of the silver. * Reduction of the co-deposited organic anti-tarnish [used in
Electronics Forum | Mon Jul 21 08:34:44 EDT 2003 | Don Bell
Blow holes/ pin holes in solder joints are the result of multiple root causes. Suggested analysis might look like this; 1) What method of solder preservation is used on the bare board. (hasl,enig, osp, etc.) HASL can leave unwanted flux residues,
winsouce.jpg)
