Electronics Forum | Thu Jul 14 04:11:16 EDT 2005 | zsver
What is written on the display at error type and error address. from error address you can find out where the error comes from.
Electronics Forum | Thu Aug 07 11:17:51 EDT 2003 | 51165
Can someone help me with a Ref Side Clamp Mesh Error on a CP643E?
Electronics Forum | Thu May 26 05:38:32 EDT 2005 | Zsolt
What is the exact error message? or error code?
Electronics Forum | Mon May 23 22:30:36 EDT 2005 | Frank
Hi all, I am trying to solve a problem with a CP643E any help on it please,It stop during production on an error for (Outside Target Position). Cheers Frank
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Thu May 26 05:46:14 EDT 2005 | ajaydoshi
What is the exact error message? or error code? Machine stop ramdonly. No error code if try to reset error it show T , turn power off. then turn off power . start again. set cam angle manually to origion & start. thanks ajay
Electronics Forum | Wed Jan 05 10:22:55 EST 2005 | Mike B
We're getting an error on our CP643 that we can't seem to make sense of. It's a D1 axis error, but we're only getting it when we run a feeder on device 140. Any advice would be appreciated.
Electronics Forum | Tue Jul 17 15:26:08 EDT 2012 | kruzer
Hi I use CP4, CP6, CP643, GLV and NXT, but i have a problem with CPIV, i cant use It with Director Fuji Flexa. i use snifer rs232 (rs232mon) to resolve problem and what i know: Computer send on rs232 to machine (every 1 min or something): vQN2105
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Thu Aug 07 13:13:51 EDT 2003 | mantis
Its been awjile since i was on a Cp643e but it sounds like there is a difference between the table board width and the fast loader width,when a board is to be transfered from the fast loader to the table the knuckles on the fast loader mechanism shou