Electronics Forum | Wed Sep 12 11:52:31 EDT 2012 | mtech88
Ben: you are right, I think the timing must be off some how. I will check the error code and post it back here. thanks David
Electronics Forum | Fri Nov 08 12:27:46 EST 2013 | zrunkle_api
That is what I'm currently doing. But we are getting errors with placement. I would like to insp. the lead them self.
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Fri Feb 13 10:13:56 EST 1998 | Simon Washer
Has anyone running the cp4-3 feeders (MC type) in 8 by 4 td flavour seen excessive wear on the aluminum body caused by the tape leaf cover and tape leaf retaining clip?? These are the black anodised aluminum feeders (new type) that we run on all cp4
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Jul 31 14:07:44 EDT 2014 | kurtiss
I found a bad solenoid and replaced it solenoid 15 on station 11. The machine is still erroring out. I also checked the holders and sensors and they seem to be ok. This error occurs when ever the machine tries to change nozzle sizes on any holder. T
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Tue Jul 17 15:26:08 EDT 2012 | kruzer
Hi I use CP4, CP6, CP643, GLV and NXT, but i have a problem with CPIV, i cant use It with Director Fuji Flexa. i use snifer rs232 (rs232mon) to resolve problem and what i know: Computer send on rs232 to machine (every 1 min or something): vQN2105
Electronics Forum | Thu Feb 11 18:51:49 EST 2010 | rodrigo
Hi All, I'm setting up the F4G software for our line (currently using MCS30). I made an adapter to connect the CP4 line (that was connected to the MCS30) to the PC. Then I tried to transmit a program but I keep getting this error: 41A27F9D: Error o
Electronics Forum | Sat Aug 22 10:25:11 EDT 1998 | Ben Salisbury
| We are using PCBs of CEM3 Material with bare copper fiducials. The whole | board is of bare copper with a lacquer coating (Coats brother S2974). | The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as | well as Fuji CP4-3. In bo
winsouce.jpg)
